U059E-00

JCB U059E-00 – Aftertreatment System ECU or main Engine Control Module (ECM): Downstream NOx Sensor Temp Signal CAN Error

Issue description

The aftertreatment control module has detected a loss or invalidity of the temperature signal data communicated from the downstream NOx sensor over the CAN bus. This indicates a communication breakdown between the NOx sensor's integrated control module and the primary engine or aftertreatment ECU, which can trigger the MIL or AdBlue warning light, and may cause torque limitation or a start-countdown.

Applies to these machines

  • 406 SV Wheel Loader
  • 407 SV Wheel Loader
  • 409 SV Wheel Loader
  • Kohler KDI-TC Engines (KDI1903, KDI2504)
  • Ecomax Tier 4 Engines

Check the cause

  1. Visually inspect the downstream NOx sensor wiring harness and connectors for chafing, melting, corrosion, or moisture ingress. Pay close attention to harness routing to ensure it is not pinched or rubbing against other components.

  2. Check the under-bonnet fuse box for blown fuses related to the aftertreatment system (NOx sensors and AdBlue heater often share a fuse).

  3. Scan for related fault codes, such as upstream NOx sensor codes (e.g., U059F), which could indicate a systemic issue or shared power supply fault.

  4. Verify the NOx sensor module is receiving the correct voltage and has a solid ground connection using a multimeter.

  5. Perform a CAN bus integrity check by measuring resistance between CAN High and CAN Low (should be approximately 60 Ohms with ignition off). With the system powered on, check the voltage on the CAN lines relative to ground.

  6. Use a scan tool to monitor live data and verify if the module can communicate. Check if reported NOx and temperature values are frozen, at a maximum, or read zero, which may indicate a failed sensor element.

Repair steps

  1. Confirm the fault

    After performing the initial diagnostic checks, confirm the fault is still present.

  2. Isolate faulty component

    If a shared fuse is blowing, unplug the downstream NOx sensor and replace the fuse. If the fuse no longer blows, the downstream NOx sensor assembly is likely shorted internally.

  3. Repair wiring and connectors

    If damage was found during inspection, repair the wiring or replace the connector pigtail. Ensure all connections are clean, secure, and sealed against moisture.

  4. Replace downstream NOx sensor

    If wiring and power checks are good, replace the sensor assembly. Disconnect the battery, unplug the module, unbolt it, and use a 22mm wrench to unscrew the probe from the exhaust (use penetrating oil if seized). Install the new probe, torque to manufacturer specifications, mount the module, and reconnect the battery.

  5. Clear codes and reset system

    Use a diagnostic tool to clear all related fault codes. Perform an SCR system reset or relearn procedure if required, then test drive the machine to verify the repair.

Parts you might need

(5)
  • JCB OEM part. Cross-reference with machine serial number.

  • JCB OEM part. Cross-reference with machine serial number.

  • Downstream NOx Sensor

    0281006533

    Bosch OEM equivalent part number.

  • Downstream NOx Sensor

    0281006534

    Bosch OEM equivalent part number.

  • Downstream NOx Sensor

    0281006535

    Bosch OEM equivalent part number.

Get help to fix this fault by requesting a quote

Browse other JCB codes