U059E-08

JCB U059E-08 – ECU: Upstream NOx Sensor Communication Fault

Issue description

The Engine Control Unit (ECU) has detected a CAN bus message error related to the O2 signal status from the upstream NOx sensor. This indicates a communication issue where the expected data from the sensor module is missing, incomplete, or invalid, rather than a direct fault with the O2 reading itself. It points to a failure in the data link between the sensor module and the ECU.

Applies to these machines

  • JS220

Check the cause

  1. Record the full fault code and attempt to clear it using a diagnostic tool to determine if the fault is intermittent or persistent

  2. Check battery voltage to ensure it is stable and correct, as low voltage can cause unpredictable CAN bus errors

  3. Inspect all related battery and chassis ground connections to ensure they are clean, tight, and free from corrosion

  4. Visually inspect the wiring harness between the upstream NOx sensor and the ECU for signs of damage such as chafing, rubbing against hot exhaust components, melting, or breaks

  5. Inspect the electrical connectors at the sensor module and ECU for corrosion (often green or white powder), bent or pushed-out pins, and moisture ingress

  6. With the battery disconnected, measure CAN bus resistance across CAN High and CAN Low pins (should be approximately 60 Ohms)

  7. Measure the sensor heater resistance across the heater circuit pins on the sensor side (expected value is 2 to 6 Ohms)

  8. Monitor live data for plausible NOx and O2 readings; frozen, erratic, or zeroed data points to a sensor or communication failure

Repair steps

  1. Address power and ground issues

    If low voltage or poor grounds were identified during testing, rectify these issues first as they can be the root cause of the communication fault.

  2. Repair wiring and connectors

    If damage, corrosion, or loose pins are found, repair or replace the affected wiring and connectors using approved splice connectors. Clear codes and re-test.

  3. Replace the upstream NOx sensor

    If diagnostics point to an internal sensor failure (e.g., incorrect heater resistance or no communication despite good wiring), replace the sensor assembly. Allow exhaust to cool, remove with a 22mm cutaway socket (in severe cases, the top of the sensor may need to be cut off to allow a standard six-point socket to be used), clean threads with an M20 x 1.5 thread chaser or tap, apply ceramic anti-seize to threads only, torque to specification, securely mount the new sensor's control module, and connect the wiring harness.

  4. Perform post-replacement reset

    Use a JCB diagnostic tool to perform a reset or calibration procedure so the ECU recognizes the new component. Clear all fault codes and perform an extended drive or work cycle to confirm the repair.

Parts you might need

(6)
  • Sensor, NOx, Upstream

    400/J8554

    OEM part number. Verify fitment by serial number.

  • Sensor, NOx, Upstream (24V)

    320/D9839

    Specified as 24V for JS220. Verify fitment by serial number.

  • Sensor, NOx, Upstream

    333/W9804

    OEM part number. Verify fitment by serial number.

  • Sensor, NOx, Upstream

    400/14470

    OEM part number. Verify fitment by serial number.

  • Sensor, NOx, Upstream (Aftermarket)

    0281006533

    Bosch aftermarket cross-reference. Confirm compatibility.

  • Sensor, NOx, Upstream (Aftermarket)

    5WK96755A

    Continental aftermarket cross-reference. Confirm compatibility.

Get help to fix this fault by requesting a quote

Browse other JCB codes