U059E-87

JCB U059E-87 – Aftertreatment ECU: Upstream NOx Sensor CAN Bus Off Error

Issue description

The Aftertreatment ECU has detected a missing CAN message from the upstream NOx sensor, indicating a complete loss of communication between the sensor and the control system. The '-87' suffix specifically designates a 'Missing Message' failure type rather than invalid data. When this fault is active, the engine control system will typically enter a Reduced Power Mode or Engine Derate to ensure emissions compliance and protect the aftertreatment system.

Applies to these machines

  • JS Series Excavators
  • Telehandlers
  • Wheeled Loaders
  • Machines with Tier 4 Final (T4F) engines
  • Machines with JCB EcoMAX engines

Check the cause

  1. Record and clear the fault code using a diagnostic tool (like JCB 444 Engine Diagnostics) to determine if it is a transient issue or a hard fault.

  2. Check battery and system voltage; ensure the battery is fully charged and all ground straps are clean, tight, and free of corrosion, as low voltage can trigger CAN errors.

  3. Visually inspect the entire wiring harness between the upstream NOx sensor and the Aftertreatment ECU for rubbing, chafing, melted insulation, or sharp kinks.

  4. Disconnect and inspect the electrical connectors at both the sensor and the ECU for corrosion, bent or pushed-out pins, moisture ingress, and ensure they latch securely.

  5. Check the vehicle's fuse box for any blown fuses related to the emissions system, as a short in one component can cause a loss of power and communication to others.

Repair steps

  1. Locate and cool sensor

    Locate the upstream NOx sensor in the exhaust system before the Selective Catalytic Reduction (SCR) catalyst. Allow the exhaust system to cool completely to prevent severe burns.

  2. Remove old sensor

    Disconnect the electrical connector and unclip the wiring harness. Using a 22mm offset NOx sensor socket, carefully loosen and remove the sensor probe from the exhaust bung. If the sensor is seized, apply penetrating oil and allow it to soak; avoid using excessive force to prevent damaging the exhaust pipe. Remove the sensor's control module from its mounting bracket.

  3. Prepare exhaust bung

    Clean the threads in the exhaust bung using an M20x1.5 thread chaser to remove rust or carbon buildup, ensuring a proper seal and correct installation depth.

  4. Install new sensor

    Apply a small amount of anti-seize compound to the sensor threads (avoiding the tip). Thread the new sensor in by hand, then tighten to the manufacturer's specified torque. Mount the control module, route the harness safely away from hot/moving parts, and connect the electrical connector.

  5. Clear codes and calibrate

    Reconnect the battery if disconnected. Use a diagnostic tool to clear the U059E-87 fault code. Start the engine and perform any required drive cycle or calibration routine for the new sensor to be recognized. Monitor the system to ensure the fault code does not reappear.

Parts you might need

(1)
  • Upstream NOx Sensor

    Contact an official JCB dealer with the machine's model and serial number to obtain the correct replacement part. Internal software is calibrated for specific engines.

Get help to fix this fault by requesting a quote

Browse other JCB codes