U059E-93

JCB U059E-93 – Engine Control Unit (ECU) or Aftertreatment System ECU: Upstream NOx Sensor CAN Message Error

Issue description

The engine control unit (ECU) has detected a CAN bus message error regarding the NOx level from the upstream NOx sensor. This indicates a communication or data integrity issue where the expected NOx data message is either missing or invalid. This condition is typically caused by a failure of the sensor itself, a loss of power to the sensor circuit, or physical damage to the CAN bus wiring harness.

Applies to these machines

  • Tier 4 Ecomax Engine Machines
  • Telehandlers
  • Excavators
  • Backhoe Loaders

Check the cause

  1. Check for additional active or stored fault codes, particularly those related to power supply, heater circuits, or the broader CAN bus network

  2. Check power supply fuses and relays (the upstream NOx sensor often shares a power source with the downstream sensor and DEF tank heater)

  3. Visually inspect the upstream NOx sensor wiring harness and connectors for chafing, melting from exhaust heat, corrosion ("green death"), or bent/backed-out pins

  4. Monitor live data from the upstream NOx sensor using a diagnostic tool to determine if the reading is stuck at zero, stuck at maximum, or completely missing

Repair steps

  1. Safety First

    Ensure the engine is stopped and the exhaust system has cooled down to prevent burns.

  2. Locate and Disconnect

    Identify the faulty upstream NOx sensor (located before the SCR catalyst). Disconnect its electrical connector and carefully inspect it.

  3. Test the Circuit

    Test the wiring harness for continuity, short to ground, and short to power between the sensor connector and the ECU.

  4. Sensor Removal

    If the sensor is deemed faulty, use the appropriate size wrench to remove it from the exhaust pipe.

  5. Thread Preparation

    Clean the threads in the exhaust port using a thread chaser tool (commonly M20 x 1.5 for NOx sensors) to ensure a smooth installation and proper seal.

  6. Install New Sensor

    Apply a small amount of a suitable anti-seize compound to the new sensor's threads, being careful not to get any on the sensor tip. Thread the new sensor in by hand and then torque it to the manufacturer's specification.

  7. Reconnect and Secure

    Reconnect the electrical connector, ensuring it clicks into place. Secure the wiring harness in its original clips, making sure it is clear of hot or vibrating parts.

  8. Clear Fault Codes and Reset Adaptations

    Use a diagnostic tool to clear the U059E-93 fault code. Following this, a reset or recalibration procedure for the NOx sensor must be performed to tell the ECU to learn the baseline values of the new sensor.

  9. Perform Drive Cycle

    After clearing codes and resetting adaptations, operate the machine to allow the ECU to verify the repair and for the SCR system to recalibrate.

Parts you might need

(5)
  • Upstream NOx Sensor

    400/J8554

    OEM JCB part. Verify exact part number by machine serial number.

  • Cross-references with Bosch 0281006533.

  • Short cable variant. Verify fitment.

  • Upstream NOx Sensor

    333/W9804

    Alternate OEM part number.

  • Upstream NOx Sensor

    400/14470

    Alternate OEM part number.

Get help to fix this fault by requesting a quote

Browse other JCB codes