U059E-94

JCB U059E-94 – ECU: CAN Bus Message Error for O2 Level from Upstream NOx Sensor

Issue description

The Engine Control Module (ECU) is not receiving a valid CAN bus message regarding the oxygen (O2) level from the upstream NOx sensor. This communication error indicates a potential failure in the sensor itself, its dedicated control module, the wiring harness, or the connectors linking it to the ECU.

Applies to these machines

  • JCB machines with EcoMAX engines
  • JCB JS Excavators
  • JCB Wheel Loaders
  • JCB Backhoe Loaders
  • JCB Telehandlers

Check the cause

  1. Check for other fault codes - presence of both upstream and downstream NOx sensor codes (e.g., U059E and U059F) may indicate a shared power supply issue like a blown fuse

  2. Inspect battery and ground health - ensure the battery is fully charged and main ground straps are clean and tight, as weak voltage causes CAN errors

  3. Visually inspect the wiring harness and connectors to the upstream NOx sensor for rubbing, chafing, melting, or physical damage; unplug the connector at the NOx sensor module and the corresponding connector at the ECU to check for corrosion (green or white powder), bent or broken pins, and moisture intrusion

  4. Check the fuse supplying power to the NOx sensors and the after-treatment system

Repair steps

  1. Safety preparation

    Stop the engine and allow the exhaust system to cool completely before starting work.

  2. Locate the sensor

    Locate the upstream NOx sensor in the exhaust system before the SCR catalyst, often on the diesel particulate filter (DPF) housing.

  3. Remove sensor module

    Disconnect the main electrical connector from the sensor's control module. Unbolt the module from the machine frame (typically held by two 10mm nuts).

  4. Remove sensor probe

    Using a 22mm (or 7/8") slotted socket, carefully loosen and remove the sensor probe from the exhaust pipe. If the sensor is seized and being replaced, the wires can be cut to use a standard deep-well socket.

  5. Clean exhaust threads

    Clean the threads in the exhaust bung using an M20 x 1.5 thread chaser or tap to ensure the new sensor installs smoothly and seals correctly.

  6. Install new sensor assembly

    Thread the new sensor probe by hand to avoid cross-threading, then tighten to OEM torque specs. Bolt the control module to the frame, route the wiring harness away from hot components, and plug in the connector.

  7. Clear Fault Codes

    Using a diagnostic tool, clear the U059E-94 fault code from the ECU.

  8. Verify the Repair

    Start the engine and let it run through a complete drive cycle to ensure the fault code does not return.

Parts you might need

(4)
  • Upstream NOx Sensor (NOx Sensor "A")

    OEM part number varies by machine. Contact an authorized JCB dealer with the machine's serial number.

  • Upstream NOx Sensor (Aftermarket)

    0281006533

    Verify compatibility with machine serial number before use.

  • Upstream NOx Sensor (Aftermarket)

    0281006505

    Verify compatibility with machine serial number before use.

  • Upstream NOx Sensor (Aftermarket)

    5WK96755A

    Continental/Siemens VDO. Verify compatibility with machine serial number before use.

Get help to fix this fault by requesting a quote

Browse other JCB codes