U059F-62

JCB U059F-62 – Aftertreatment System ECU: Downstream NOx Sensor NH3 Level Error

Issue description

The Aftertreatment System ECU has detected a CAN bus message error or implausible signal regarding the ammonia (NH3) level from the downstream NOx sensor. Because NOx sensors are cross-sensitive to ammonia used in the SCR system, this communication breakdown disrupts the aftertreatment process. This fault typically forces the machine into a reduced power or limp mode to prevent damage and ensure emissions compliance.

Applies to these machines

  • Backhoe Loaders
  • Telehandlers
  • Loadalls
  • Excavators

Check the cause

  1. Read all active and stored fault codes to identify related aftertreatment, NOx, or CAN bus issues.

  2. Inspect the downstream NOx sensor wiring harness for rubbing, melting, or corrosion, and check connectors for moisture or bent pins.

  3. Check the exhaust system for leaks between the DEF injector and the downstream NOx sensor, as leaks can introduce oxygen and skew readings.

  4. Verify battery voltage (minimum 12.4V) and ensure the NOx sensor module has proper power and ground connections.

  5. Monitor live data for both NOx sensors; downstream readings should be significantly lower than upstream under load. Frozen or erratic data points to a sensor or communication fault.

  6. Verify the quality and concentration of the Diesel Exhaust Fluid (DEF).

Repair steps

  1. Prepare machine

    Allow the exhaust system to cool completely. Disconnect the vehicle's battery to prevent electrical shorts.

  2. Remove faulty sensor

    Locate the downstream NOx sensor after the SCR catalyst. Disconnect the electrical harness, unbolt the control module, and carefully remove the sensor probe from the exhaust pipe using a specialized socket. Use penetrating oil if seized.

  3. Clean exhaust bung

    Clean the threads in the exhaust pipe bung using an M20 x 1.5 thread chaser to remove rust or carbon buildup and ensure proper installation depth.

  4. Install new sensor

    Apply anti-seize compound to the new sensor threads (avoiding the tip). Hand-thread the probe into the bung, tighten to specification, mount the control module, and reconnect the wiring harness.

  5. Calibrate and test

    Reconnect the battery, clear all fault codes, and perform the required NOx sensor relearn or calibration procedure using a diagnostic tool. Run the engine to operating temperature and verify live data.

Parts you might need

(2)
  • Downstream NOx Sensor Assembly

    320/A9215

    Sensor probe and control module are calibrated as a matched pair and must be replaced together. Verify exact part number by machine serial number.

  • Frequently misidentified in online catalogs as a NOx sensor; functionally an accelerometer/knock sensor or intake air temperature sensor for Ecomax engines.

Get help to fix this fault by requesting a quote

Browse other JCB codes