U059F-87

JCB U059F-87 – ECU: CAN Bus Off Error from Downstream NOx Sensor

Issue description

The Engine Control Unit (ECU) has lost communication with the downstream Nitrogen Oxide (NOx) sensor over the CAN bus, indicating a 'Missing Message' failure. The downstream NOx sensor measures NOx concentration after the SCR system to verify catalyst efficiency. A communication breakdown will typically trigger an amber warning light and may cause the engine to enter a derated or limp-home mode to reduce emissions and prevent aftertreatment damage.

Applies to these machines

  • Machines with JCB Ecomax Tier 4 Final engines
  • Tracked Excavators
  • Wheeled Excavators
  • Wheel Loaders
  • JCB 406 SV
  • Backhoe Loaders
  • Telehandlers
  • Other equipment using similar aftertreatment architectures

Check the cause

  1. Perform a visual inspection of the downstream NOx sensor, wiring harness, and connectors for chafing, melting, corrosion, or improper routing against hot/vibrating components.

  2. Disconnect the sensor module connector and inspect terminals for corrosion (green/white powder), bent pins, or a loose fit. Ensure it is clean and dry.

  3. Verify power and ground to the NOx sensor module using a multimeter with the ignition on.

  4. Check for a valid CAN bus signal at the sensor module connector using a handheld oscilloscope (look for a clean, square waveform).

  5. Clear fault codes using a diagnostic tool and operate the machine to see if the code returns, which may indicate an intermittent connection.

Repair steps

  1. Prepare machine for service

    Park the machine on level ground, engage the parking brake, turn off the engine, and allow the exhaust system to cool completely.

  2. Locate sensor and module

    Locate the downstream NOx sensor in the exhaust system after the SCR catalyst. Find its control module, which is typically mounted on the frame rail.

  3. Remove faulty sensor

    Disconnect the electrical connector, unbolt the module from the frame, and cut any securing zip ties. Use a 22mm NOx/O2 sensor socket to unscrew the probe from the exhaust pipe. Apply penetrating oil if seized, or cut the wire to use a deep-well socket for better leverage.

  4. Install new sensor

    Clean the exhaust pipe bung threads and apply a small amount of anti-seize to the new sensor threads (avoiding the tip). Thread the sensor into the pipe, tighten to manufacturer's specified torque, mount the module, reconnect the electrical connector, and secure the harness with new zip ties clear of hot/moving parts.

  5. Clear codes and test

    Clear any stored fault codes from the ECU using a diagnostic tool. Start the engine, run under load or test drive, and monitor to ensure the fault code does not return.

Parts you might need

(6)
  • Cross-referenced with Bosch 0281006533 and 0281006534. Verify with serial number.

  • Engine NOx sensor (down stream)

    400/J4546

    Verify with serial number.

  • Nox Sensor

    400/14470

    Verify with serial number.

  • Verify with serial number.

  • Verify with serial number.

  • Nox Sensor 2-3 (Downstream)

    10901016902

    Kohler part number for machines equipped with Rehlko (formerly Kohler) engines.

Get help to fix this fault by requesting a quote

Browse other JCB codes