JCB U059F-94 – ECU: CAN Bus Message Error for O2 Level from Downstream NOx Sensor
Issue description
The Engine Control Unit (ECU) has detected an unexpected operation error in the CAN bus messages related to the Oxygen (O2) level data transmitted by the downstream NOx sensor. This indicates a communication issue, data corruption, or signal integrity problem with the sensor or its circuit, rather than a fault with the O2 level itself. The downstream NOx sensor is critical for measuring nitrogen oxides and oxygen after the Selective Catalytic Reduction (SCR) system to verify aftertreatment efficiency.
Applies to these machines
5 machines- Tier 4 EcoMAX engines
- 3CX
- 4CX
- Telehandlers
- Excavators
Check the cause
Record and clear faults using a diagnostic tool to determine if the code returns immediately or was an intermittent glitch
Visually inspect the downstream NOx sensor wiring harness and connectors for chafing, rubbing, melted insulation, corrosion ('green death'), moisture, debris, or bent, loose, or backed-out pins
Verify stable battery voltage and inspect main battery terminals and chassis ground connections
Check for correct voltage and a clean ground directly at the NOx sensor connector according to the wiring diagram
Perform a CAN bus integrity check by measuring resistance between CAN High and CAN Low with the battery disconnected (should be approximately 60 Ohms)
Check the CAN lines for any shorts to power or ground
Repair steps
Isolate the fault
Disconnect the downstream NOx sensor, clear the fault codes, and check if a different code (such as an open circuit fault) appears. This confirms the ECU is communicating on the circuit up to the point of disconnection.
Replace NOx sensor assembly
If wiring and power are intact, replace the downstream NOx sensor and integrated control module as a complete assembly. Allow the exhaust to cool, remove the sensor probe, apply ceramic anti-seize to the new sensor threads (avoiding the tip), install, and torque to 40-60 Nm. Mount the new module and connect the harness.
Perform system reset and verification
Clear all fault codes from the ECU. Perform a 'NOx sensor replacement' or 'SCR system reset' function using a diagnostic tool if required by the system. Run the machine under load to warm up the aftertreatment system and verify the ECU recognizes the new sensor.
Parts you might need
(2)- Downstream NOx Sensor320/A9103
Bosch cross-reference: 0281006533, 0281006534. Verify fitment by serial number.
- Downstream NOx Sensor (12V)320/D9836
12V system sensor. Verify fitment by serial number.
Get help to fix this fault by requesting a quote