JCB U059F-97 – Engine ECU: CAN Bus Message Error Downstream NOx Sensor
Issue description
The Engine ECU has detected a Controller Area Network (CAN) bus message error regarding the NOx signal status from the downstream NOx sensor. The '-97' suffix indicates that the component or system operation is obstructed or blocked. This means the ECU is not receiving a valid communication signal from the sensor located after the Selective Catalytic Reduction (SCR) system, which may result in an engine torque derate as a safety measure.
Applies to these machines
1 machine- EcoMAX Tier 4 Final
Check the cause
Scan for any other active or stored fault codes related to the CAN bus or the aftertreatment system
Visually inspect the wiring harness and connectors between the downstream NOx sensor and the ECU for chafing, corrosion, or loose connections
Inspect the exhaust system for any leaks between the upstream and downstream sensors that could introduce oxygen and skew readings
Monitor live data from the NOx sensors using a diagnostic tool; a healthy downstream sensor should show a >85% reduction in NOx compared to the upstream sensor on a warmed-up engine
Measure the resistance of the CAN bus at a breakout point (should be approximately 60 ohms)
Check for continuity and resistance in the signal wires (resistance over 0.5 ohms indicates a wiring fault)
With the sensor disconnected and cold, measure the resistance across the heater pins (expected range is 2-6 ohms; outside this indicates internal heater failure)
Repair steps
Address related faults
If any other related fault codes are present, diagnose and repair those first before proceeding with NOx sensor diagnostics.
Repair wiring and connectors
If any issues are found during the visual inspection or wiring checks, repair or replace the damaged sections of the harness or connectors.
Replace downstream NOx sensor
If the diagnostic checks point to a faulty sensor (e.g., failed heater circuit check or erratic live data) and wiring is intact, replace the downstream NOx sensor. It is not a repairable component.
Clear adaptations and fault codes
Use a diagnostic tool to clear the fault codes and reset any learned adaptations for the NOx sensor or SCR system. Failure to do so may result in the fault code returning even with a new part.
Perform a system test
Operate the machine to allow the system to run its self-tests and verify that the repair has been successful and the fault code does not reappear.
Parts you might need
(1)Downstream NOx Sensor
Part numbers are specific to the machine model and serial number. Consult an official JCB parts catalog using the machine's specific details.
Get help to fix this fault by requesting a quote