JCB U1901 – LiveLink ECU: Internal Voltage Below Normal
Issue description
The LiveLink ECU has detected that its own internal operating voltage has dropped below a predefined threshold. This indicates a potential issue with the power supply to or within the LiveLink module itself, which can affect the proper functioning of the machine's telematics and monitoring system.
Applies to these machines
5 machines- Tier 4i Loadall
- 437 T4F
- 3CX
- 531-70
- JS220
Check the cause
Record and clear fault codes, noting if U1901 returns immediately or is accompanied by U1900-16 (Vehicle Battery Voltage Below Normal)
Check the main vehicle battery and charging system, as a weak battery or faulty alternator can cause low voltage across all ECUs
Visually inspect the wiring harness and connectors leading to the LiveLink ECU for corrosion, frayed, pinched, or melted insulation, and loose housings
Locate the LiveLink ECU (often found within the cab, behind the instrument cluster or under an access panel)
Check the fused power input (typically 2A) and fused ignition input (1A) at the LiveLink ECU connector for battery voltage with the ignition on
Perform a load test on the power supply wire using a small test lamp to check for high resistance in the circuit
Measure resistance between the LiveLink ECU ground pins and chassis ground (should be less than 1 ohm) and perform a voltage drop test between the ECU's ground pin and the negative battery terminal while the system is active
Repair steps
Address preliminary findings
Clean corroded terminals, repair or replace damaged sections of the harness, and ensure the battery and charging system are functioning correctly.
Isolate the internal fault
If all external wiring, power, and grounds are confirmed to be good, the fault is likely a faulty internal voltage regulator within the LiveLink ECU.
Replace LiveLink ECU
Disconnect the vehicle's battery, remove the old ECU, and install the new LiveLink ECU. Reconnect the battery, clear any stored fault codes using a diagnostic tool, and verify that the U1901 code does not return.
Parts you might need
(4)- LiveLink ECU (LiveLink 4)728/J8518
Verify correct part number by machine serial number
LiveLink AD+ ECU
728/D7505For JS Range
- LiveLink Cab Exterior Harness721/X1888
Replace if harness damage is found
- LiveLink II Harness332/K8903
Replace if harness damage is found
Get help to fix this fault by requesting a quote