U1906

JCB U1906 – LiveLink ECU: Accelerometer Internal Failure

Issue description

The system has detected an internal failure within the accelerometer that is integral to the JCB LiveLink telematics module. This accelerometer is used to monitor machine movements such as harsh braking, acceleration, and cornering. The fault indicates a hardware problem within the electronic component itself, rather than an issue with external wiring or connections, though no further details about the specific nature of the internal failure are provided by the system.

Applies to these machines

  • 437 T4F Wheel Loaders
  • Tier 4i Loadall
  • Machines with Perkins engines and LiveLink integration
  • Backhoe loaders with LiveLink
  • Excavators with LiveLink
  • Telehandlers with LiveLink

Check the cause

  1. Verify the Fault Code: Use a diagnostic tool like JCB ServiceMaster to confirm that U1906-96 is the active and logged fault. Note any other accompanying LiveLink or CAN network faults.

  2. Inspect the LiveLink Module: Locate the LiveLink ECU. Its location can vary but is often found within the cab, sometimes under an instrument panel.

  3. Check for Environmental Damage: Carefully inspect the LiveLink module and its connectors for any signs of water ingress, corrosion ('green death'), or physical damage. In some cases, multiple fault codes have been resolved by cleaning and drying a module that was found to be wet inside.

  4. Inspect Power and Ground Connections: Ensure the LiveLink module has a clean, secure power and ground supply. Poor connections can sometimes cause erratic behavior in electronic modules. The LiveLink 4 unit, for example, requires a fused 2A power input and a secure ground connection.

  5. Clear Fault Codes: After inspection and cleaning, clear the fault codes and operate the machine to see if the U1906 code returns immediately. If it does, it further points to a definitive internal hardware failure.

Repair steps

  1. Make the Machine Safe

    Park the machine on level ground, lower all attachments, and turn off the engine. Disconnect the machine's battery to de-energize the electrical system.

  2. Access the LiveLink Module

    Locate and access the faulty LiveLink ECU.

  3. Disconnect and Remove

    Carefully disconnect the wiring harness connector(s) from the module. Remove the bolts or fixings securing the module to the machine frame and remove it.

  4. Install the New Module

    Mount the new LiveLink module in the same position as the old one, ensuring it is secure.

  5. Reconnect and Secure

    Reconnect the wiring harness to the new module. Ensure the connection is clean and clicks into place securely.

  6. Finalize and Test

    Reconnect the machine's battery. Turn the ignition on and use a diagnostic tool to check for any active faults. It may be necessary to configure or register the new LiveLink unit to the machine and the JCB telematics system. Start the machine and verify that the U1906 fault code does not reappear.

Parts you might need

(1)
  • LiveLink ECU / LiveLink Module

    728/C6423

    Part number varies by machine model and year (728/C6423 is an example for a 3CX). Must verify with machine serial number.

Get help to fix this fault by requesting a quote

Browse other JCB codes