JCB U2106 – ECM: CAN Timeout Fault
Issue description
The system has detected a CAN timeout fault, indicating a loss of communication within the CAN network. This fault is triggered when a control module, typically the Engine Control Module (ECM), fails to receive an expected message from another critical module (such as the Transmission Control Module) within a predefined time. This disrupts the controller's ability to receive or transmit data properly and can severely affect machine operations.
Applies to these machines
2 machines- JS Series
- JS130LC
Check the cause
Record and clear the code using a diagnostic tool to observe if it returns immediately, which indicates a hard fault.
Check battery voltage stability and ensure all ground straps are clean and tight, as weak batteries or poor grounds can trigger CAN bus errors.
Visually inspect wiring harnesses and connectors at the ECM, TCM, and CAN network for chafing, abrasion, corrosion ('green death'), or damaged/backed-out pins.
Perform a termination resistor check with power off: measure resistance across CAN_H and CAN_L. A healthy network reads approximately 60 ohms (120 ohms indicates a missing resistor or open circuit; significantly lower indicates an extra resistor or a short circuit).
Perform a CAN line voltage check with power on (engine off): CAN_H should be approximately 2.5V to 3.0V, and CAN_L should be 2.0V to 2.5V. Incorrect voltages can point to a short to power, a short to ground, or a faulty transceiver in one of the modules.
Check for shorts to ground with power off: measure resistance from CAN_H and CAN_L to ground. The reading should be very high (mega-ohms or open).
Repair steps
Isolate the faulty module
If diagnostic checks suggest a module is bringing down the network, disconnect modules from the CAN bus one at a time while monitoring communication status with a scan tool. When communication is restored, the last module disconnected is likely the source of the fault.
Repair harness and connectors
If visual inspection reveals damaged wiring or corroded connectors, repair or replace the affected section of the harness. Ensure all connections are clean, tight, and properly sealed.
Replace termination resistor
If the termination resistor check indicates a faulty or missing resistor (e.g., reading 120 ohms), replace the terminating resistor plugged into the harness.
Replace faulty control module
If a specific control module (ECM or TCM) is identified as faulty and cannot be repaired, replace it. New control modules require programming to the machine's specific configuration and serial number using a JCB-approved diagnostic tool.
Parts you might need
(4)- CAN Terminating Resistor7213/0036
Alternative OEM part number: 334/T6570
- Engine Control Unit (ECU)332/K6848
For JCB JS130LC. Various part numbers exist depending on year/configuration (e.g., 334-K0853, 728-J3013). Always verify with serial number.
Transmission Control Unit (TCM)
403/C2656Alternative OEM part numbers: 550/42134, 728/80051. Highly specific to machine model and transmission type. Programming required.
Wiring Harness and Connectors
Generic parts; part numbers vary by specific harness.
Get help to fix this fault by requesting a quote