John Deere 000107.00 – ECU / CCU: Engine Air Filter Obstruction

The engine's control system has detected a severe air filter restriction (SPN 107, FMI 00). The air filter is significantly clogged, preventing the engine from breathing properly. This condition is considered the most severe level for this issue and will lead to significant performance limitations to protect the engine from damage.

• 9230
• 9330
• 9430
• 9530
• 9630
• 318D
• 319D
• 320D
• 323D

1. 1

   Visually inspect the air intake system for any blockages or collapsed ducting

2. 2

   Confirm that the fault code is active by cycling the tractor's power to clear any temporary codes

3. 3

   Check the air filter restriction indicator, if equipped (a red plunger in the window indicates a clogged filter)

1. 1

   Access the air filter housing

   Unfasten the retaining clips to remove the filter cover.

2. 2

   Remove the primary air filter

   Grasp the handle and slide the primary air filter out of the canister housing.

3. 3

   Clean the housing

   Clean any dirt and debris from the inside of the canister housing and cover.

4. 4

   Replace the secondary air filter

   It is recommended to replace the secondary filter with every other primary filter change. Do not attempt to clean the secondary filter. Pull the handle to remove the old secondary filter and install the new one immediately to prevent dust from entering the intake system. Ensure the new secondary filter is properly seated and sealed.

5. 5

   Install the new primary air filter

   Slide the new primary filter into the housing until it is properly seated.

6. 6

   Reassemble

   Install the air filter housing cover and fasten the retaining clips.

7. 7

   Clear the code

   After replacing the filters, start the engine to see if the fault code clears. If the code persists, further diagnosis by a John Deere dealer may be required.