SSU001079.04

John Deere SSU001079.04 – SSU: Steering Flowmeter Supply Voltage Low

Issue description

This fault code indicates a low voltage condition within the sensor supply circuit of the Steering System Control Unit (SSU). Specifically, the steering flowmeter supply on circuit cc# 046 is out of range low. When the SSU detects that the voltage supplied to this critical steering sensor has dropped below the acceptable range, it triggers a 'Repair as soon as possible' alert. As a result, the AutoTrac™ assisted steering system may become inoperable or disabled.

Applies to these machines

  • 7630
  • 7720
  • 7730
  • 7820
  • 7830
  • 7920
  • 7930
  • 8100
  • 8110
  • 8120
  • 8200
  • 8210
  • 8220
  • 8300
  • 8310
  • 8320
  • 8400
  • 8410
  • 8420
  • 8430
  • 8520
  • 9330
  • 9430
  • 9530
  • 9630
  • 9560 STS
  • 9660 CTS
  • 9660 STS
  • 9760 STS
  • 9860 STS

Check the cause

  1. Restart the vehicle by shutting down the machine, waiting 30 seconds, and restarting to see if a temporary communication error clears.

  2. Check overall system voltage by reducing electrical load, increasing engine RPM to maximize alternator output, and inspecting batteries and the alternator for damage, debris, or corrosion.

  3. Inspect all fuses related to the SSU and steering system (such as fuse F23).

  4. Visually inspect the wiring harness and connectors on circuit cc# 046 between the SSU controller and the steering flowmeter sensor for damage, corrosion, or loose connections.

Repair steps

  1. Confirm fault code

    Confirm the presence of the active SSU 001079.04 fault code using the machine's diagnostic display.

  2. Perform preliminary checks

    Perform the preliminary diagnostic checks listed above.

  3. Test sensor voltage

    Using a digital multimeter and the machine's technical manual wiring diagrams for circuit cc# 046, test the voltage at the steering flowmeter sensor connector.

  4. Load test wiring harness

    Conduct a load test on the wiring harness between the SSU and the sensor to check for high resistance or a voltage drop under load, which would indicate a wiring issue.

  5. Replace faulty component

    If the wiring is confirmed to be in good condition and providing the correct voltage from the SSU, the fault is likely with the sensor itself. Replace the faulty component (wiring or sensor).

  6. Clear codes and calibrate

    Clear the fault code from the SSU. Some steering system components may require calibration after replacement.

  7. Verify repair

    Operate the machine and the AutoTrac™ system to verify the repair and ensure the code does not return.

Parts you might need

(6)
  • Steering Flow Meter Sensor Assembly

    RE209847

    OEM John Deere part. Compatible with numerous 7020, 8000, and 9000 series tractors and various STS combines.

  • Alternative steering flow meter sensor assembly.

  • Steering System Control Unit (SSU)

    SJ32536

    Listed for R4023 Sprayers and M4000 series tractors. Verify fitment.

  • Used on a wide variety of medium and large tractors (6R, 7R, 8R, 9R series). Verify fitment.

  • Steering System Control Unit (SSU)

    RE596096

    Verify fitment by machine model and serial number.

  • Steering System Control Unit (SSU)

    RE342809

    Verify fitment by machine model and serial number.

Get help to fix this fault by requesting a quote

Browse other John Deere codes