SFA001079.05

John Deere SFA001079.05 – SFA: SFA Sensor Supply Voltage Low

Issue description

The Suspended Front Axle (SFA) control unit has detected an open circuit or abnormally low current in the power supply circuit for one or more of the SFA sensors. This condition can disrupt the proper operation of the front suspension, and the system may not pressurize correctly.

Applies to these machines

  • 7610
  • 7710
  • 7810
  • 6520
  • 6620
  • 6820
  • 6920
  • 6920S
  • 8335R
  • 8310R
  • 6110M
  • 6120M
  • 6130M
  • 6145M
  • 6155M
  • 6175M
  • 6195M
  • 6110R
  • 6120R
  • 6130R
  • 7600
  • 7700
  • 7800

Check the cause

  1. Inspect fuse F30, which is related to the SFA system

  2. Visually inspect the wiring harnesses and connectors associated with the SFA position sensors for damage, corrosion, or loose connections

  3. Check the area around the batteries and alternator for any damage or debris

  4. Check for other active fault codes (e.g., SFA 522290.04) that may pinpoint a specific faulty position sensor

  5. Measure the resistance of the SFA position sensors and compare left and right readings (a functioning sensor may read approximately 4.9-6.0 kOhms between certain pins)

Repair steps

  1. Repair wiring and fuses

    If any damaged wiring, corroded connectors, or a blown F30 fuse were found during the diagnostic checks, repair or replace these components first.

  2. Prepare for SFA calibration

    Park the tractor on a level surface with the shift lever in PARK and the engine OFF. Ensure suspension cylinders are not fully extended. Disconnect the axle position feedback sensor link from the lower pivot pin and push it all the way up to its stop (tape in place if necessary).

  3. Perform SFA calibration

    Start the engine and run at approximately 1200 RPM. Access the SFA calibration menu (e.g., SFA/20/CAL on 7810 models). Operate the hazard lights switch to initiate calibration. Within 30 seconds, pull the sensor link down. The cylinders will retract; once they do, shut the engine OFF.

  4. Verify calibration success

    Check the display for a completion message (e.g., 'END'). If an error message appears, the underlying issue has not been resolved and requires further diagnosis.

  5. Replace faulty components

    If the fault persists after wiring repairs and calibration, replace the identified faulty SFA position sensor. If all sensors and wiring are intact, replace the SFA control unit as a last resort.

Parts you might need

(4)
  • Compatible with 7600, 7610, 7700, 7710, 7800, and 7810 tractors.

  • SFA Position Sensor (Related)

    RE24467

    Potentially related sensor part number, though specific application to the SFA system is less clear.

  • Potentially related sensor part number, though specific application to the SFA system is less clear.

  • SFA Control Unit

    Model-specific component; verify part number with your specific machine's serial number through an authorized dealer.

Get help to fix this fault by requesting a quote

Browse other John Deere codes