John Deere 108.02 – Engine Control Unit (ECU): The Signal From The Internal Barometric Sensor Is Faulty

The Engine Control Unit (ECU) has detected an invalid signal from the internal barometric pressure sensor. This sensor is not providing valid data to the ECU, which affects the proper operation of systems relying on atmospheric pressure data and can negatively impact optimal engine performance.

• 5085E
• 5090E
• 5090EL
• 5100E
• 5065M
• 5075M
• 5085M
• 5100M
• 5100MH
• 5100ML
• 5115ML
• 5095M
• 5095MH
• 5105M
• 5015ML
• 5090M
• 5115M
• 6110M
• 6120M
• 6130M
• 6145M
• 6155M
• 6175M
• 6195M
• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 6115M
• 6125M
• 7185J
• 7195J
• 7205J
• 7630
• 7730
• 7830
• 7930
• 8130
• 8230
• 8330
• 8430
• 8530
• 9230
• 9330
• 9430
• 9530
• 9630
• 9470RT
• 9520RT
• 9570RT
• 4930
• 250GR
• E240LC

1. 1

   Inspect the engine air filter for severe restriction, which can cause manifold and exhaust pressure calculation anomalies that the ECU misinterprets as an invalid barometric reading.

2. 2

   Check with a John Deere dealer for ECU software updates, as past updates have included patches to prevent nuisance 108.02 codes.

3. 3

   Clear the code and retest the machine to rule out a temporary glitch or nuisance code.

1. 1

   Replace the Engine Air Filter

   If the filter is dirty or restricted, replace it with a new OEM filter, clear the code, and test the machine.

2. 2

   Replace the ECU

   If the code persists, the internal barometric pressure sensor has permanently failed. Because the sensor cannot be serviced separately from the circuit board, the entire Engine Control Unit (ECU) must be replaced.

3. 3

   Reprogram the ECU

   Install the new ECU and have a certified John Deere dealer flash the controller with the correct payload/software for your specific machine's serial number and engine configuration.