John Deere 1080: Height Sensor Power 2 Voltage Too Low

The voltage for Height Sensor Power 2 is below 4.75VDC, which may affect the operation of the HEADERTRAK Angle Sensor and the Header Raise Pressure Sensor. The issue may be caused by a faulty voltage regulator of the Header Control Unit or a short in the wiring.

1. 1

   Voltage regulator of the Header Control Unit

2. 2

   Wiring associated with Height Sensor Power 2

1. 1

   Inspect

   Inspect the wiring associated with Height Sensor Power 2 for any signs of damage, wear, or short circuits.

2. 2

   Test

   Test the voltage regulator of the Header Control Unit to determine if it is functioning properly.

3. 3

   Replace

   If the voltage regulator is found to be faulty, replace it with a compatible replacement.