001231.14

John Deere 001231.14 – TMA: Tracks Steering CAN Bus Fault

Issue description

The TMA (Tractor Module A) controller has detected a malfunction on the Tracks Steering CAN Bus. This indicates a communication issue within the dedicated network for the steering system, preventing the TMA from communicating effectively with other necessary steering components. The .14 suffix typically points to a special instruction or a general communication fault.

Applies to these machines

  • 8310RT
  • 8335RT
  • 8360RT

Check the cause

  1. Perform a visual inspection of the Tracks Steering CAN Bus wiring harness and connectors for chafed or pinched wires, loose or corroded connectors, and moisture intrusion

  2. Check the diagnostic display for other active or stored fault codes, particularly missing messages from other controllers (ECU, PTP, TIP, etc.)

  3. Perform a power cycle (cold boot) by disconnecting the battery or controller power supply to allow all modules to reset completely

  4. Perform a CAN Bus resistance check: Turn ignition off, disconnect battery, and measure resistance between CAN High (Pin C - yellow wire) and CAN Low (Pin D - green wire). A healthy bus should read approximately 60 Ohms

Repair steps

  1. Isolate the fault

    If the CAN bus resistance is incorrect (e.g., 120 Ohms indicates a missing terminating resistor, open circuit indicates both missing or a break, low Ohms indicates a short), systematically disconnect controllers and harness sections one at a time and re-measure resistance.

  2. Inspect harness and connectors

    Disconnect the suspected harness section and inspect pins and sockets for damage, corrosion, or a loose fit. Check continuity of the CAN High and CAN Low wires within that section using a multimeter.

  3. Isolate controllers

    Disconnect each controller on the Tracks Steering CAN Bus one by one, re-checking the bus resistance each time. If the resistance returns to a normal 60 Ohms after disconnecting a particular controller, that controller is likely the source of the fault.

  4. Inspect TMA controller

    Inspect the TMA controller's connectors for any signs of damage or corrosion. If all other components and wiring on the Tracks Steering CAN Bus check out, the TMA controller itself may be faulty and require replacement.

  5. Update software/firmware

    Check with a John Deere dealer to ensure the TMA controller has the latest software and firmware installed to resolve any potential software conflicts.

Parts you might need

(1)
  • Alternative part number RE255851 for some models. Always verify the correct part number for your machine's specific serial number with a John Deere dealer.

Get help to fix this fault by requesting a quote

Browse other John Deere codes