John Deere 1500 – C03: Cornerpost Display Switch Stuck Closed
Issue description
A button on the Cornerpost Display Unit 1 has been held in the closed (pressed) position for more than 30 seconds. The control unit expects switches to be activated only momentarily, indicating a physically stuck button or a short in the switch's wiring. This is a Priority 3 fault, meaning it is stored in the system for diagnostic purposes but will not trigger a warning light or alarm for the operator.
Applies to these machines
20 machines- 9540 WTS
- 9560 WTS
- 9580 WTS
- 9640 WTS
- 9660 WTS
- 9680 WTS
- 9660 CTS
- 9560 STS
- 9650 STS
- 9660 STS
- 9750 STS
- 9760 STS
- 9860 STS
- 7630
- 7720
- 7820
- 7920
- 8130
- 8230
- 8330
Check the cause
Access Diagnostic Trouble Codes by turning the key to the 'RUN' position, pressing the diagnostic switch on the corner post display (display will show 'dIA'), navigating to the 'C03' address, and pressing 'Enter'.
Enter Diagnostic Address Mode by navigating to address C03, 33 to view the status of the display unit buttons (1 indicates pushed, 0 indicates released).
Identify the stuck switch by systematically pressing and releasing each button while observing the diagnostic display. A stuck switch will consistently show a status of 1 even when not being physically pressed.
Visually inspect the buttons on the corner post display for any signs of physical damage, debris, or sticking that might prevent them from returning to the open position.
Repair steps
Attempt to free the stuck button
If a button is identified as stuck, gently clean around it with a soft brush and compressed air to dislodge any debris that may be causing it to stick.
Cycle power and clear codes
Cycle the machine's power off and on. Clear the fault codes by scrolling to the end of the code list until 'CLr?' is displayed and pressing the enter switch.
Verify repair
Operate the machine and check if fault code 1500 reappears. If it does not return, the issue is resolved.
Repair or replace module
If the button remains stuck internally and the fault code persists, replace the entire Corner Post Display Module or send it to a specialized electronics repair service. Individual buttons are not typically sold as separate replacement parts.
Parts you might need
(1)- Corner Post Display ModuleRE325413
OEM John Deere part. Supersedes previous numbers RE246544 and RE221495. Confirm fitment with your specific machine's serial number.
Get help to fix this fault by requesting a quote