000161.03

John Deere 000161.03 – TCU: Transmission Input Speed Sensor High Voltage

Issue description

The Transmission Control Unit (TCU) has detected that the voltage signal from the transmission input speed sensor is above the normal operating range, or the circuit is shorted to a high voltage source. This sensor measures the rotational speed of the transmission's input shaft, providing crucial data for smooth gear shifting and overall machine performance.

Applies to these machines

  • 6000 Series
  • 6420
  • 6820
  • 6920
  • 6M Series
  • 6R Series
  • 7R Series
  • 8R Series
  • 9RX Series
  • 8000 Series
  • 9000 Series

Check the cause

  1. Cycle power by turning the machine's ignition off and back on to see if the fault code is intermittent and clears itself

  2. Visually inspect the wiring harness and connectors leading to the transmission input speed sensor for frayed or broken wires, corrosion on pins, or loose connections

  3. Using a multimeter, verify the sensor is receiving the correct reference voltage (e.g., 5V or 12V) and has a solid ground connection with the key on

  4. Visually inspect the sensor for physical damage and check the gap between the sensor and the timing gear or tone ring

  5. Test the sensor: For a 2-wire variable reluctance sensor, measure resistance across terminals with the sensor disconnected (typically 200-1,000 ohms; an open loop 'OL' or reading far outside spec suggests a faulty sensor). For a 3-wire Hall-effect sensor, test for a pulsing DC voltage signal as the shaft rotates using an oscilloscope

Repair steps

  1. Locate the sensor

    Find the transmission input speed sensor, typically mounted on the transmission housing (top or side depending on the model). Cab or other components may need removal for access.

  2. Prepare for removal

    Drain some of the transmission oil if necessary to prevent spillage when the sensor is removed.

  3. Disconnect and remove

    Disconnect the electrical connector, remove the retaining bolt(s), and carefully pull the old sensor out of the transmission housing.

  4. Install the new sensor

    Lightly lubricate the O-ring on the new sensor with clean hydraulic oil. Insert into the housing and tighten retaining bolt(s) to the manufacturer's specified torque. Do not overtighten.

  5. Reconnect and refill

    Securely attach the electrical connector. If oil was drained, refill the transmission to the proper level with the correct fluid.

  6. Clear codes and test

    Start the machine, use a diagnostic tool to clear the fault code, and operate the machine to ensure correct shifting and that the code does not return.

Parts you might need

(5)
  • Compatible with 6820, 6920, 8000, and 9000 series tractors

  • Transmission Speed Sensor

    AT514900

    Used on various wheel loaders and construction equipment

  • Fits 6M, 6R, 7R, 8R, and 9RX series tractors

  • Speed Sensor

    T179510

    For various loaders and construction equipment

  • Exact part numbers vary heavily by transmission option (e.g., IVT vs. PowrQuad) and tractor serial number. Always verify the exact part number against the John Deere parts catalog using your machine's specific PIN/Serial Number.

Get help to fix this fault by requesting a quote

Browse other John Deere codes