161.04

John Deere 161.04 – PTA / TCU: Transmission Input Speed Sensor Low Voltage

Issue description

The Transmission Input Speed Sensor is reporting a voltage level below the normal operating range to the Transmission Module IVT (PTA). This low voltage condition disrupts the signals sent to the transmission control module, which can negatively affect the proper operation and performance of the transmission.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R
  • 6230
  • 6330
  • 6430
  • 6010
  • 6110
  • 6210
  • 6310
  • 6410
  • 6510
  • 6610
  • 6810
  • 6910
  • 6820
  • 6920
  • 6920S

Check the cause

  1. Inspect the B61 sensor connection to ensure it is securely connected and examine the sensor body for physical damage or wear.

  2. Inspect the wiring harness leading to the sensor (specifically lead 6075) for signs of damage, disconnection, or wear that could cause a short to ground.

  3. Perform a circuit and operational test on the B61 Transmission Input Speed Sending Unit to verify if it is providing accurate readings or has failed completely.

  4. Ensure that the TCU/PTA control unit software is up-to-date, as updates can include improvements in sensor signal processing.

Repair steps

  1. Locate sensor

    Locate the B61 Transmission Input Speed Sensor on the transmission housing.

  2. Disconnect harness

    Disconnect the electrical harness from the sensor.

  3. Remove breather

    Remove the transmission breather (if it obstructs access on your specific model).

  4. Remove sensor

    Remove the transmission input speed sensor cap screw and pull the old sensor out of the housing.

  5. Insert new sensor

    Insert the new B61 transmission input speed sensor.

  6. Install cap screw

    Install and tighten the sensor cap screw. Torque specification: 27 N·m (20 lb-ft).

  7. Reinstall breather

    Reinstall the transmission breather vent (if removed). Torque specification: 14 N·m (124 lb-in).

  8. Reconnect and clear code

    Reconnect the electrical harness and clear the 000161.04 fault code from the PTA/TCU module.

Parts you might need

(5)
  • Also referred to as B61 Sensor or Speed Transmitt. Fits 6R series and various AutoPowr/IVT gearboxes. Crosses over to ZF components for ZF ECCOM 1.5 / TRAXON AutoPowr.

  • Listed as compatible with a wide range of models, including 6R 145, 6R 155, 6R 165, 6R 175, 6R 195, 6R 215, 6110R, 6120R, and 6130R.

  • This part is listed as fitting numerous 6R models, including 6110R, 6120R, 6130R, 6140R, 6145R, 6150R, 6155R, 6170R, 6175R, 6190R, 6195R, 6210R, and 6215R.

  • Compatible with a broad range of tractors, including 6110R, 6115R, 6120R, 6125R, and 6130R.

  • Transmission Speed Sensor

    AT514900

    A general transmission speed sensor.

Get help to fix this fault by requesting a quote

Browse other John Deere codes