161.11

John Deere 161.11 – PTA / TCU: Sensor for Transmission Input Speed, Signal does Not Match Engine Speed

Issue description

The transmission control unit has detected a discrepancy or loss of the signal from the transmission input speed sensor. This signal reports the rotational speed of the transmission's input shaft. A loss of this signal disrupts the proper operation of the Infinitely Variable Transmission (IVT), which can lead to hard shifting or the disabling of cruise control.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R
  • 6230 Premium
  • 6330 Premium
  • 6430 Premium

Check the cause

  1. Inspect the B61 Sensor Connection: Ensure the sensor is securely connected and examine it for any physical damage or signs of wear.

  2. Check Wiring and Connectors: Inspect the wiring harness leading to the sensor (specifically noting lead 6075, which carries the signal input) for any signs of damage, disconnection, chafing, or shorts to ground.

  3. Verify CAN BUS Communication: Verify that the ECU is properly broadcasting the engine RPM over the CAN BUS to the TCU/PTA.

  4. Test Sensor Functionality: Use a diagnostic tool to monitor the live transmission input speed. Look for erratic readings or an implausible drop to 0 RPM while the engine is running.

  5. Software Update: Check if the TCU/PTA control unit software is up-to-date, as updates often include improvements in sensor signal processing.

Repair steps

  1. Power down machine

    Turn off the tractor and disconnect the battery to protect the control modules.

  2. Locate sensor

    Locate the B61 Transmission Input Speed Sensor on the transmission housing.

  3. Disconnect harness

    Carefully unplug the electrical connector from the sensor, checking the pins for corrosion.

  4. Remove sensor

    Remove the retaining bolt(s) securing the sensor to the transmission and pull the sensor out.

  5. Clean mounting port

    Wipe the mounting area clean to ensure no dirt or debris falls into the transmission oil.

  6. Install new sensor

    Insert the replacement sensor and tighten the retaining hardware to factory specifications.

  7. Reconnect electrical and power

    Plug the electrical harness back into the sensor and reconnect the battery.

  8. Clear codes and test

    Use a diagnostic tool to clear the 000161.11 code. Start the engine and test drive the tractor, verifying that the transmission input speed now matches the engine speed via live data.

Parts you might need

(3)
  • Primary John Deere OEM part number. Always verify exact fitment against the machine's specific serial number and transmission type (e.g., IVT vs. PowrQuad).

  • Primary replacement part for 6R series. Multi-application fitment.

  • Transmission Input Speed Sensor

    AT514900

    Alternative multi-application speed sensor. Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other John Deere codes