000168.03

John Deere 000168.03 – Front Chassis Module: Voltage to Module Over 16 Volts Front Chassis Module

Issue description

The electrical system has detected that the voltage supplied to the Front Chassis Module (also known as PTF or SFA) exceeds 16 volts. The system logs this error to protect the sensitive electronic components within the module from potential damage due to overvoltage, which typically indicates a malfunctioning charging system or an electrical issue affecting the module's power supply.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R
  • 6110M
  • 6120M
  • 6130M
  • 6145M
  • 6155M
  • 6175M
  • 6195M
  • 7R Series

Check the cause

  1. Restart the tractor and cycle the key switch to see if the fault code is a temporary glitch

  2. Visually inspect the area around the batteries and alternator for any signs of damage, corrosion, or accumulated debris

  3. Inspect the relevant fuses for the chassis module, specifically checking fuse F30 for the SFA module

  4. Test battery voltage with the engine off using a voltmeter (should be 12.4-12.7 volts)

  5. Test the charging system by running the engine at high idle; voltage at the battery terminals should be stable between 13.2 and 14.8 volts. A reading climbing above 15 volts indicates a faulty voltage regulator

Repair steps

  1. Replace alternator assembly

    If the charging system test indicates an overcharging situation (voltage above 15 volts), the alternator's internal voltage regulator is likely malfunctioning. Replace the entire alternator assembly.

  2. Inspect and clean module connections

    If the charging system is functioning correctly, disconnect the battery and locate the Front Chassis Module (PTF/SFA). Disconnect its main electrical connector, inspect pins for corrosion or a loose fit, and clean with contact cleaner. Trace the power and ground wires looking for chafing, breaks, or shorts.

  3. Replace Front Chassis Module

    If the charging system and wiring are confirmed to be in good condition, the fault likely lies within the Front Chassis Module itself. Replace the module. It is highly recommended to have a certified John Deere technician perform this task, as module replacement may require programming to the specific tractor.

Parts you might need

(4)
  • Alternator

    Required if the internal voltage regulator is faulty causing an overcharge condition.

  • Compatible with various 6R, 7R, 8R, and 9R series tractors. Verify fitment by serial number.

  • Multi-Functional Control Module

    RE573556

    Compatible with various 6R and 7R models. Verify fitment by serial number.

  • Listed for 6175R and 6R 130 models. Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other John Deere codes