John Deere 200128 – LCU: HillMaster Engage Signal Short to 12V
Issue description
The Left Control Unit (LCU) is receiving an unexpected 12-volt signal from the Hillmaster engagement circuit (cc# 447) even when the operator has not activated the Hillmaster system. This condition indicates either a short circuit to a 12-volt power source within the wiring harness or an internal fault within the Left Control Unit itself.
Applies to these machines
27 machines- S560
- S660
- S670
- S680
- S690
- S760
- S770
- S780
- S790
- 9570 STS
- 9670 STS
- 9770 STS
- 9870 STS
- 9540
- 9560
- 9580
- 9640
- 9660
- 9680
- T550
- T560
- T660
- T670
- W540
- W550
- W650
- W660
Check the cause
Visually inspect the Hillmaster system wiring harness, specifically the engage signal wire (cc# 447), for chafing, melting, or corrosion that could cause a short to a nearby power wire
Check for any other active or stored fault codes that may provide additional clues to the location and nature of the electrical issue
Repair steps
Isolate the fault
Disconnect the relevant electrical connector from the Left Control Unit (E03). With the key in the 'ON' position, engine off, and Hillmaster system disengaged, use a multimeter to test for voltage on the pin corresponding to the Hillmaster Engage Signal (cc# 447) in the disconnected harness connector.
Repair wiring harness (if shorted)
If 12V DC is present on the pin in the harness during step 1, it confirms a short circuit to a power source within the wiring. Trace the cc# 447 wire to identify the location of the short and repair or replace the damaged section.
Replace Left Control Unit (if internal fault)
If no voltage is present on the pin in the harness during step 1, the fault likely lies within the Left Control Unit itself, and the unit will require replacement.
Test and replace engage switch
If the Hillmaster engage switch is suspected to be faulty, test it for proper operation and replace it if necessary.
Parts you might need
(3)- Left Control UnitAXE66868
Control Unit 1 (LC1) Vehicle Controller, Left Side. A remanufactured option may also be available.
Hillmaster Engage Switch
Consult a John Deere dealer with the machine's serial number. Generic switches (AT150348, AM131341, AA59147) exist but compatibility is not guaranteed.
Wiring Harness
Highly specific to the machine's model and serial number. Contact a John Deere dealer for the correct part.
Get help to fix this fault by requesting a quote