John Deere 200347: No Pulses from Sieve Adjust Actuator

The system detects that no pulses are being received from the Sieve Adjust Actuator for 30 seconds after a command to open or close is issued. This fault must be cleared before the Sieve Adjust Actuator can be operated.

1. 1

   The Sieve Adjust Actuator

2. 2

   The circuit connected to the Sieve Adjust Actuator

3. 3

   The command signal to the Sieve Adjust Actuator

1. 1

   Verify the command signal to the Sieve Adjust Actuator

   Ensure that the command to open or close is being sent correctly from the control system.

2. 2

   Inspect the connection to the Sieve Adjust Actuator

   Check for loose, damaged, or disconnected wiring related to the Sieve Adjust Actuator.

3. 3

   Test the Sieve Adjust Actuator

   Use diagnostic tools to confirm whether the Sieve Adjust Actuator is receiving and responding to commands.

4. 4

   Clear the fault code

   Once the issue is resolved, clear the fault code using the appropriate diagnostic procedure.