John Deere 002025.09 – ICU: CAN Bus ATC Message Missing
Issue description
The Instrument Control Unit (ICU) has lost communication with the Automatic Temperature Control (ATC) module over the CAN bus. The '.09' suffix indicates a communication system error where an expected message from the ATC is absent or has timed out. This disruption can be caused by a blown fuse, wiring harness damage, or an internal failure of the ATC module itself.
Applies to these machines
22 machines- 7720
- 7820
- 7920
- 7630
- 7730
- 7830
- 7930
- 8130
- 8230
- 8330
- 8430
- 8530
- 9230
- 9330
- 9430
- 9530
- 9630
- 7185J
- 7195J
- 7205J
- 7210J
- 7225J
Check the cause
Check for other active fault codes to help pinpoint the root cause of the communication error
Restart the tractor to determine if the fault is a temporary communication glitch
Check fuses supplying the modules. For 7020 and 7030 Series, check fuse F42. For general ATC message missing faults, check fuse F6
Visually inspect the CAN bus wiring harness and connectors (especially at the ICU and ATC modules) for chafing, corrosion, or loose connections
With the battery disconnected, measure resistance between CAN High and CAN Low wires (often pins C and D of the diagnostic connector). Approximately 60 ohms indicates intact terminating resistors; around 120 ohms suggests one is missing or faulty
Repair steps
Isolate the ATC module
If fuses are intact and the fault specifies an ATC message missing, focus diagnostics on the ATC module and its specific wiring.
Test CAN bus voltages
With the key on and engine off, measure CAN bus voltages to ground. CAN High should be approximately 2.5V to 3.0V, and CAN Low should be 2.0V to 2.5V. Significant deviations indicate a module issue or wiring short.
Perform a wiggle test
While monitoring the fault code status or CAN voltages with a breakout harness, gently wiggle the wiring harness at connectors and potential rub points to identify intermittent connections.
Disconnect modules sequentially
If CAN bus resistance is incorrect, unplug modules one at a time. If resistance returns to a normal value (e.g., 120 ohms with one terminator unplugged), the disconnected module or its internal resistor is likely faulty.
Replace faulty components
Based on diagnostic results, replace the identified faulty component, such as a damaged wiring harness section, a failed terminating resistor, or the ATC control unit.
Parts you might need
(10)Verify fitment by serial number
Verify fitment by serial number
Verify fitment by serial number
ATC Control Unit
Highly specific to machine model; verify through John Deere parts catalog
Wiring Harness or Connectors
Identify specific section via parts catalog if damage is found
Fuses
Standard automotive-style fuses of correct amperage
Fits many 8000, 8010, 8020, and 9000 series tractors
Automatic Temperature Control (ATC) Module
RE176357Fits various 8020 and 9020 series tractors
- Temperature ControlRE46742
Specific models not detailed
Component of ATC system; failure usually produces a different code
Get help to fix this fault by requesting a quote