John Deere 002035.09 – ICU: CAN BUS Message Fault in Direct Drive Gear Shift Module
Issue description
The Instrument Control Unit (ICU) has failed to receive an expected CAN BUS message from the Direct Drive Gear Shift Module (transmission controller) within the expected timeframe. This communication breakdown prevents proper gear shifting and can affect other tractor functions that rely on data from the transmission controller.
Applies to these machines
8 machines- 6R Series (including models with DirectDrive transmissions)
- 7R Series
- 8R Series
- 9R Series
- 7020 Series
- 7030 Series
- 9030 Series
- Various J-Series models
Check the cause
Restart the tractor to see if the code clears, as intermittent communication issues can sometimes be resolved by a power cycle
Inspect fuses related to the electronic control units, specifically checking fuses F15 and F35 which may supply power to the transmission controllers
Ensure battery terminals are clean and tight, as a poor ground connection can cause widespread CAN BUS errors
Visually inspect the CAN BUS wiring harness for chafing, corrosion, or rodent damage, paying close attention to sections running to the transmission control module
With the key on, check CAN BUS voltages using a multimeter (CAN High should be 2.5-3.5V, CAN Low should be 1.5-2.5V)
With the key off and battery disconnected, measure CAN BUS resistance between CAN High and CAN Low (should be approximately 60 Ohms; 120 Ohms indicates a missing or faulty terminating resistor)
Repair steps
Isolate faulty component
If CAN BUS resistance and voltage readings are incorrect, unplug controllers one by one from the network. If readings return to normal, the disconnected controller is likely faulty.
Inspect connectors
Disconnect electrical connectors at the Direct Drive Gear Shift Module and the ICU. Inspect pins and sockets for corrosion, moisture intrusion, or damage. Clean or repair as necessary.
Test the module
If all wiring and connections are in good condition, test the Direct Drive Gear Shift Module using specialized John Deere diagnostic equipment.
Replace and calibrate module
If the module is determined to be faulty, replace it. The new module will require programming or calibration by a certified technician to communicate correctly with other control units.
Parts you might need
(7)Direct Drive Gear Shift Module (TCM/HCU/PTP)
Specific part number depends on tractor model and serial number
- Mini Boot Style CAN TerminatorRE207311
CAN BUS terminating resistor
- Black 2-pin CAN Terminator57M11134
CAN BUS terminating resistor
- Passive 4-pin CAN TerminatorRE70623
CAN BUS terminating resistor
CAN BUS terminating resistor
Transmission Shifter Control
RE296489May be required if fault originates from shifter assembly in cab
May be required if fault originates from shifter assembly in cab
Get help to fix this fault by requesting a quote