ICU002036.09

John Deere ICU002036.09 – ICU: Missing Message from Front PTO Controller

Issue description

The Instrument Control Unit (ICU) has detected an electronic communication error on the CAN bus network. Specifically, the ICU is not receiving expected messages from the Front PTO (Power Take-Off) Control Unit, also known as the PTF controller. The '.09' suffix indicates a 'message missing' failure mode, which means the module has lost communication with the rest of the machine's network.

Applies to these machines

  • 7715
  • 7815
  • 7720
  • 7820
  • 7920
  • 7630
  • 7730
  • 7830
  • 7930
  • 8245R
  • 8270R
  • 8295R
  • 8320R
  • 8345R
  • 8R 280
  • 6110M
  • 6120M
  • 6130M
  • 6145M
  • 6155M
  • 6175M
  • 6195M

Check the cause

  1. Restart the tractor to see if the communication between control units resets and clears the code

  2. Check fuse F15, which supplies power to the PTF controller, ensuring it is not blown and is securely seated

  3. Visually inspect the wiring harness leading to the PTF controller (especially behind the cab) for pinched, chafed, or broken wires

  4. Unplug the connector at the PTF controller and inspect the pins and sockets for corrosion, moisture, or damage

  5. Verify the PTF controller is receiving proper power and has a solid ground connection using a multimeter

  6. Check CAN bus integrity with the battery disconnected by measuring resistance between CAN High (Yellow wire) and CAN Low (Green wire) circuits. A healthy bus reads approximately 60 Ohms; 120 Ohms indicates an issue with a terminating resistor

Repair steps

  1. Isolate the faulty component

    Based on the diagnostic checks, determine if the root cause is a blown fuse, compromised power/ground supply, damaged CAN bus wiring, or a failed PTF controller.

  2. Repair wiring

    If a broken or corroded wire is found in the harness, repair it using appropriate splicing techniques and ensure the repair is completely sealed from moisture.

  3. Replace the PTF controller

    If the wiring is confirmed good and the controller is receiving power and ground but still not communicating, replace the PTF controller. The new controller will need to be programmed by a John Deere dealer to function correctly.

Parts you might need

(3)
  • OEM John Deere Front PTO Control. Verify exact part number with a dealer using the machine's serial number.

  • Fits many 7x30 and 8x30 series tractors. Verify exact part number with a dealer using the machine's serial number.

  • 15 Amp Fuse

    Replacement for fuse F15 if blown.

Get help to fix this fault by requesting a quote

Browse other John Deere codes