John Deere 002049.09 – BLC: CAB Message Missing on CAN Bus
Issue description
A communication failure has been detected on the Controller Area Network (CAN bus). One or more electronic control units (ECUs) have stopped receiving expected data messages from the primary cab controller (Operator Interface Module). This indicates an issue within the network's communication pathway or an internal fault within the Main Control Module (BLC) itself, rather than a failure of the module logging the code.
Applies to these machines
29 machines- 5090M
- 5100M
- 5M Series
- 6145J
- 6165J
- 6J Series
- 6R Series
- 7630
- 7715
- 7720
- 7730
- 7815
- 7820
- 7830
- 7920
- 7930
- 7030 Series
- 7R Series
- 8R Series
- 8RT Series
- 9230
- 9330
- 9430
- 9530
- 9630
- 9030 Series
- 9R Series
- 9RT Series
- 9RX Series
Check the cause
Restart the tractor to see if a temporary communication glitch clears
Check relevant fuses (F22, F35, F30, F15) depending on the tractor model and logging controller
Perform a CAN bus resistance test with power OFF (expect approximately 60 Ω between CAN High and CAN Low)
Perform a CAN bus voltage test with power ON (expect CAN High at 2.5V-3.0V and CAN Low at 2.0V-2.5V)
Visually inspect main CAN bus harnesses and connectors for chafing, pinching, or corrosion, especially at the cab firewall and armrest harness
Repair steps
Perform preliminary checks
Address any blown fuses (such as F22, F35, F30, or F15) and restart the tractor to see if the code clears.
Verify CAN bus integrity
Conduct resistance and voltage tests on the CAN bus. A resistance reading of 120 Ω indicates a missing terminating resistor or wire break, while ~0 Ω indicates a short. Voltage should be 2.5-3.0V on CAN High and 2.0-2.5V on CAN Low.
Isolate harness or resistor faults
If resistance or voltage is incorrect, locate and inspect the terminating resistors. Unplug controllers one by one while monitoring CAN resistance to isolate a faulty harness section or an internally shorted controller.
Inspect the Cab Controller
If the CAN bus backbone is healthy (correct resistance and voltage), check for secure power and ground connections directly at the Cab Controller module. Inspect the connector for corrosion or pushed-out pins.
Replace faulty component
Replace any identified faulty terminating resistors or repair damaged wiring. If the CAN bus is healthy and the Cab Controller has proper power and ground but still fails to communicate, replace the Cab Controller.
Parts you might need
(9)Fits various 7030, 8030, 8R, and 9030 series tractors. Verify by serial number.
- Cab Vehicle ControllerAT328223
Verify fitment by serial number.
Cab Controller
AL218297Associated with Cab Controllers for 6R series tractors.
- Cab ControllerAL216420
Associated with Cab Controllers for 6R series tractors.
Cab Controller
AL214058Associated with Cab Controllers for 6R series tractors.
Cab Controller
AL213068Associated with Cab Controllers for 6R series tractors.
Verify fitment by serial number.
- CAN Bus Terminating ResistorRE207311
Mini Boot Style 6-pin CAN terminator used on a wide range of tractors.
Verify fitment by serial number.
Get help to fix this fault by requesting a quote