John Deere 2050.06 – Cab Load Center (CLC) or Basic Load Center (BLC): Circuit Current High

The control unit has detected an excessive electrical current draw across its circuits. Specifically, the module detects that the total load current on the control units is above 130 amps while the circuit board temperature is below 115°C (239°F), or above 100 amps while the circuit board temperature is above 115°C (239°F) for more than 2 seconds.

• 6110M
• 6120M
• 6130M
• 6145M
• 6155M
• 6175M
• 6195M
• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 7630
• 7730
• 7830
• 7930
• 8130
• 8230
• 8330
• 8430
• 8530
• 8225R
• 8245R
• 8270R
• 8295R
• 8320R
• 8345R
• 9230
• 9330
• 9430
• 9530
• 9630
• 6090MC
• 6100MC
• 6110MC
• 6090RC
• 6100RC
• 6110RC

1. 1

   Restart the engine to verify if the active Diagnostic Trouble Code reappears, as this can sometimes reset communication messages.

2. 2

   Inspect for aftermarket accessories (e.g., flood lights, hazard lights, window wipers) wired directly into the cab's load center, as this is the most common cause of excessive current draw.

1. 1

   Safely park the tractor and turn off the engine.

2. 2

   Remove all operator-customized accessories that draw heavy current from the cab circuits.

   This includes aftermarket flood lights, hazard lights, and window wipers.

3. 3

   Turn the tractor back on and monitor the CommandCenter display to see if the CLC/BLC 002050.06 code clears.

4. 4

   If the code still exists after removing the customized accessories, have a dealer repair the electrical system.

   The issue lies internally within the wiring harness or the Load Center control unit itself, and it may require replacing and reprogramming the CLC/BLC module.