002139.09

John Deere 002139.09 – RPT: Rear PTO CAN Bus Communication Failure

Issue description

A fault has been detected in the CAN BUS message communication related to the rear chassis. The Rear PTO Control Unit (RPT) has lost communication with one or more essential control modules on the network. The FMI .09 indicates an abnormal update rate, meaning the RPT is not receiving expected messages at the correct interval. This issue may affect the proper functioning of systems connected to the rear chassis, specifically the engagement and disengagement of the rear power take-off system.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6135R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R
  • 6R 110
  • 6R 120
  • 6R 130
  • 6R 140
  • 6R 145
  • 6R 150
  • 6R 155
  • 6R 165
  • 6R 175
  • 6R 185
  • 6R 195
  • 6R 215
  • 6R 230
  • 6R 250
  • 5R Series
  • 7R Series
  • 8R Series

Check the cause

  1. Visually inspect wiring harnesses connected to the RPT and nearby rear chassis controllers for chafing, cuts, pinch points, corrosion, or broken ground eyelets.

  2. Check CAN bus error counts (Passive, Warn, Off) in the tractor's display diagnostics menu to verify active network problems.

  3. Perform a CAN bus resistance check at the diagnostic port with the battery disconnected (should be approximately 60 Ohms; 120 Ohms indicates a missing terminating resistor or open circuit, while significantly lower indicates a short or extra resistor).

  4. Perform a CAN bus voltage check with ignition on and engine off (CAN High/yellow should be 2.5-3.0V; CAN Low/green should be 2.0-2.5V).

  5. Perform a wiggle test on rear chassis wiring harnesses and connectors while observing CAN bus voltages or error counts to pinpoint intermittent connections.

Repair steps

  1. Repair wiring and connectors

    Repair or replace any damaged wiring, corroded connectors, or faulty ground connections found during inspection. Ensure all connections are clean and secure. If a faulty ground is found, crimp on a new terminal and ensure a solid connection to the chassis.

  2. Isolate faulty modules

    If wiring and resistance checks are inconclusive, disconnect controllers from the CAN bus one at a time. Re-check CAN bus resistance after each disconnection. If resistance returns to normal (60 Ohms) after disconnecting a specific module (like the RPT), that module is likely the source of the fault.

  3. Update software/firmware

    Contact a John Deere dealer to check for and apply any available software or firmware updates for the RPT or other relevant modules.

  4. Replace faulty control module

    If the RPT or another specific module is identified as faulty, replace it. Note that new modules may require programming or calibration by a John Deere dealer.

Parts you might need

(2)
  • OEM John Deere part. Compatible with 6R, 7R, and 8R series tractors.

  • Rear PTO Control Module (Aftermarket)

    QTP-58479

    Aftermarket direct replacement for 5R, 6R, 7R, and 8R series.

Get help to fix this fault by requesting a quote

Browse other John Deere codes