002140.09

John Deere 002140.09 – HCC: HCC CAN BUS Message Fault

Issue description

A communication error has been detected indicating that the Rear Chassis Module (HCC) is either not sending or not receiving messages correctly on the Controller Area Network (CAN bus). The .09 FMI specifically points to an abnormal update rate, meaning messages are not being transmitted or received as expected within the system.

Applies to these machines

  • 5045E
  • 5055E
  • 5065E
  • 5075E
  • 8310RT
  • 8335RT
  • 8360RT
  • 310SJ
  • 410J

Check the cause

  1. Cycle the tractor power to see if the intermittent code clears

  2. Check for other active diagnostic trouble codes (multiple CAN bus errors may point to a wider network issue rather than a single faulty controller)

  3. Inspect the battery and charging system, ensuring all connections to the battery, starter, and frame grounds are clean, tight, and free of corrosion

  4. Check fuses related to the HCC and other control units to ensure a blown fuse hasn't cut power to the module

  5. Visually inspect the wiring harness and connectors leading to the Rear Chassis Module for chafing, pinching, or corrosion

Repair steps

  1. Check CAN bus resistance

    Turn the ignition off and disconnect the battery. Locate the 9-pin diagnostic connector and measure resistance between CAN High (Yellow wire) and CAN Low (Green wire). A healthy CAN bus should read approximately 60 Ohms. A reading of 120 Ohms indicates an open circuit or missing terminating resistor. A reading significantly lower than 60 Ohms indicates a short circuit or faulty controller.

  2. Isolate the faulty module

    If resistance is incorrect, disconnect the main connector to the Rear Chassis Module (HCC) with power off. Re-measure the CAN bus resistance. If it returns to normal (or if the fault clears upon restarting), the HCC module is likely faulty. If the problem persists, disconnect other controllers on the circuit one at a time until the faulty component or wiring section is identified.

  3. Check for shorts to power or ground

    With the key off, verify there is no continuity between each CAN line (High and Low) and chassis ground. Turn the key on (engine off) and measure voltage between each CAN line and ground. CAN High should be approximately 2.5-3.5 volts, and CAN Low should be approximately 1.5-2.5 volts. Voltages outside this range indicate a short to a power or ground source.

  4. Replace the controller

    If diagnostic steps consistently point to an internal failure of the Rear Chassis Module (HCC), replace the unit. Ensure the replacement part is correct for the specific machine model and serial number.

Parts you might need

(3)
  • Applicable to some 8R/8RT series tractors. Verify fitment by serial number.

  • Vehicle Control Module, IVT

    RE275131

    Applicable to some 8R/8RT series tractors. Verify fitment by serial number.

  • Rear Chassis Module (HCC)

    Generic part name. Exact part number varies significantly by machine series and serial number.

Get help to fix this fault by requesting a quote

Browse other John Deere codes