002140.09

John Deere 002140.09 – RPT: CAN Bus Communication Issue With RPT

Issue description

The system has detected a communication failure on the Controller Area Network (CAN) bus involving the Rear PTO Control Unit (RPT). The .09 suffix indicates an abnormal update rate, meaning the RPT is not sending or receiving messages as expected by other control modules on the network. This disruption in the communication link can lead to the malfunction of related systems.

Applies to these machines

  • 6x20
  • 6x30
  • 6R
  • 7x20
  • 7x30
  • 7R
  • 8x20
  • 8x30
  • 8R
  • 9x30
  • 9R

Check the cause

  1. Cycle the key switch to see if the communication error resolves itself

  2. Visually inspect wiring harnesses and connectors associated with the RPT and nearby control units for chafing, corrosion, loose connections, debris, or moisture ingress

  3. Ensure the battery is fully charged and connections are clean and tight (low or unstable voltage can cause unpredictable module issues)

  4. Check all fuses and relays related to the RPT and other control units on the CAN bus network

  5. Test the CAN bus terminating resistors; resistance between the CAN high and CAN low wires should be approximately 60 ohms (a reading of 120 ohms indicates a missing or faulty resistor)

Repair steps

  1. Isolate the faulty component

    Disconnect other control modules on the same CAN bus one by one to see if the fault code clears. This helps identify if another module is causing the communication issue.

  2. Check CAN bus voltages

    With the key on, use a multimeter to check the voltage on the CAN bus wires. The CAN High wire (typically yellow) should have approximately 2.5 to 3.0 volts, and the CAN Low wire (typically green) should have approximately 2.0 to 2.5 volts. Significant deviations indicate a short or open in the wiring.

  3. Test the RPT module

    If the wiring and other components are in good condition, swap in a known good RPT module to see if the problem is resolved. Note that replacement modules may require programming to the specific machine.

  4. Seek professional assistance

    If the issue persists, contact a John Deere dealer to utilize specialized diagnostic tools like Service ADVISOR™ and detailed technical manuals.

Parts you might need

(4)
  • For various 6000 and 7000 series tractors

  • Generic John Deere Control Module

  • Module

    AT174935

    Generic John Deere Module for system communication

  • Module

    PT12298

    Generic John Deere Module

Get help to fix this fault by requesting a quote

Browse other John Deere codes