John Deere 002145.06 – FCC: CAN BUS Message Fault in Dash Module
Issue description
A fault has been detected in the communication of the CAN BUS message within the Dash Module, also known as the Front Console Control unit (FCC). The FMI 06 identifier indicates a short circuit or abnormally high electrical current in the communication circuit. This issue affects the proper exchange of data between systems and can lead to erratic behavior of machine functions controlled by the FCC, such as lights, wipers, and transmission controls, and may even cause the machine to stop and shift to park.
Check the cause
Cycle machine power by turning it off, waiting a few moments, and restarting to see if the fault clears
Check battery and power supply to ensure voltage is stable and within the correct operating range
Visually inspect wiring harnesses connected to the FCC module for chafing, cuts, corrosion, or loose connections
Perform a CAN bus termination resistor check with the power off by measuring resistance between the CAN High and CAN Low wires (typically yellow and green) at a diagnostic connector or unplugged module; a healthy bus reads approximately 60 Ohms, 120 Ohms indicates a missing terminator, and other readings suggest a wiring short or faulty resistor
Check for shorts to ground by measuring resistance from both CAN High and CAN Low lines to chassis ground (should read mega-ohms or open circuit)
Repair steps
Isolate the fault
Disconnect other control modules from the CAN bus one at a time to see if the fault code disappears. This helps determine if another faulty module is disrupting communication.
Test the FCC module
If the fault persists and is isolated to the FCC circuit, the module itself may be the issue. Swap in a known good module from an identical machine for testing purposes. Note that some modules may require programming to the specific machine with tools like John Deere Service ADVISOR™.
Wiring Harness Repair
If wiring damage is found, repair or replace the affected section of the harness. Ensure all connections are clean and secure.
Replace the FCC module
If the FCC module is determined to be faulty after testing, replace it with a new unit.
Clear fault codes
After any repair, clear all diagnostic trouble codes and operate the machine to ensure the fault does not return.
Parts you might need
(5)Control Module, Front Console Control Unit
AT174935Example part number. The exact part must be identified through the John Deere parts catalog using the machine's serial number.
Example part number. The exact part must be identified through the John Deere parts catalog using the machine's serial number.
CAN Bus Cab Wiring Harness
AL208446Example part number. Verify fitment by serial number.
CAN Bus Wiring Harness
F743920Example part number. Verify fitment by serial number.
CAN Bus Extension Wiring Harness
AA70062Example part number. Verify fitment by serial number.
Get help to fix this fault by requesting a quote