John Deere 2175.09 – SCO: CAN Bus Message Cannot Be Received, Information from E-SCV XV

This fault indicates a data transfer problem on the CAN Bus network. The main controller is failing to receive the expected communication signals from the Electronic Selective Control Valve 15 (E-SCV XV). As a result, the control software may limit functionality or completely disable the operation of that specific selective control valve.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 8R Series
• 8RT Series
• 8RX Series
• 8245R
• 8400R
• 6R Series
• 7R Series
• 640L-II
• 648L-II
• 748L-II
• 848L
• 948L

1. 1

   Inspect all CAN Bus wiring harnesses routing to the E-SCV XV for signs of physical damage, chafing, loose connections, or corrosion at the pins.

2. 2

   Test the CAN Bus network for proper communication voltages (CAN High / CAN Low) using a multimeter or oscilloscope.

3. 3

   Ensure the E-SCV XV control unit is receiving proper supply voltage and has a clean ground connection.

4. 4

   Wiggle-test the harness while monitoring live data on a diagnostic tool to check for intermittent communication dropouts.

1. 1

   Secure and repair wiring

   If diagnostic checks reveal damaged wiring or corroded connectors at the E-SCV XV, repair the harness or replace the connector pigtail.

2. 2

   Recalibrate the unit

   If wiring is intact and communication is restored but the valve is still not functioning, perform a recalibration of the E-SCV XV control unit via the John Deere Service ADVISOR tool.

3. 3

   Replace the E-SCV XV

   If wiring, power, and ground are verified good but the valve still fails to broadcast its Source Address 175 message, the internal module has failed. Replace the E-SCV XV unit.

4. 4

   Clear codes and test

   After repair or replacement, clear the SCO 002175.09 code and operate the SCV to ensure the code does not return.