John Deere 002356.06 – VLC: Front Inner Flood Light Circuit Current High

The Vehicle Load Center (VLC) has detected an abnormal current in the front inner flood light circuit. The .06 FMI indicates a 'current above normal or grounded circuit' condition, typically caused by a short circuit resulting in an overcurrent state. To prevent electrical damage, the VLC will shut down the affected lighting circuit and log the fault code. The circuit will remain disabled until the fault is resolved and cleared.

• 7720
• 7820
• 7920
• 7630
• 7730
• 7830
• 7930
• 8120
• 8220
• 8320
• 8420
• 8520
• 8130
• 8230
• 8330
• 8430
• 8530
• 9330
• 9430
• 9530
• 9630
• 7810

1. 1

   Restart the tractor to see if the code clears and reappears, which helps differentiate between a transient and a persistent fault

2. 2

   Inspect the front inner flood light bulb for burnout or physical damage

3. 3

   Visually inspect the wiring harness leading to the front inner flood light for chafing, pinching, or corrosion on the connectors

4. 4

   Check for any operator-installed or customized accessories spliced into the lighting circuit that could cause excessive current draw

5. 5

   Perform a functional check by clearing the code and activating the front inner flood light to see if the code returns immediately

1. 1

   Prepare machine for service

   Park the machine safely, lower all equipment, stop the engine, and disconnect the battery ground strap.

2. 2

   Replace flood light bulb

   If the bulb was found to be faulty or burnt out during diagnostic checks, replace it with a new 12V, 65W bulb.

3. 3

   Repair wiring harness

   If any damage is found in the wiring harness (such as a short to ground), repair or replace the affected section. Ensure all connections are clean and secure.

4. 4

   Replace flood lamp assembly

   If the bulb and wiring are in good condition but the fault persists, replace the entire front inner flood lamp assembly.

5. 5

   Replace Vehicle Load Center (VLC)

   If the fault remains active after replacing the lamp and verifying the wiring, the VLC itself may be faulty. Replacement should be performed by an experienced technician, as it may require programming.