John Deere 002368.05 – CLC: Low Amps in Cab Module Circuits

The fault code indicates a low amps condition in the Cab Load Center (CLC) module circuits associated with the Left-Hand Side Wide Vehicle Warning Light, Tail Light, and Front and Rear Trailer Sockets. A low amperage reading often indicates a blown bulb, a poor connection, or a broken wire within these specific lighting circuits.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R

1. 1

   Visually inspect the bulbs for the left-hand side wide vehicle warning light, tail light, and trailer socket connections

2. 2

   Examine the wiring harnesses leading to these components for any signs of damage, corrosion, or loose connections

3. 3

   Wiggle battery cables and associated ground wires while observing system behavior to identify intermittent connection issues

4. 4

   Check the fuses for the lighting circuits (refer to the operator's manual for fuse box location and ratings)

5. 5

   Use a multimeter to check for proper voltage at the component connectors and test for high resistance in the circuit

1. 1

   Cycle power

   Cycle the tractor's main power switch off and on. Many minor electrical faults can be cleared this way.

2. 2

   Replace faulty bulbs

   If any bulbs were found to be blown during the diagnostic checks, replace them with new ones of the correct type.

3. 3

   Repair wiring and connections

   If damaged wiring, corroded connectors, or a loose ground is found, repair or replace the faulty section. For a broken ground wire eyelet, strip the damaged wire, crimp on a new terminal, and seal it with heat shrink tubing.

4. 4

   Replace components

   If the bulbs and wiring are in good condition, replace the faulty component itself (e.g., replace the entire tail light assembly or disconnect and replace the trailer socket).

5. 5

   Clear fault codes

   After completing the repairs, use a diagnostic tool to clear the fault code from the CLC module.

6. 6

   Verify repair

   Operate the lights and re-check for the fault code to ensure the repair was successful. If the code persists, further diagnosis by a qualified dealer technician may be required for the CLC module itself.