002368.06

John Deere 002368.06 – CLC or FCC: High Amp Draw On Left Turn Signal

Issue description

The control module has detected an abnormally high amperage in the electrical circuit for the left-hand turn signal. This condition typically indicates a short circuit to ground or the use of an incorrect, high-wattage bulb. Excessive current flow can lead to blown fuses, damaged wiring, or failure of the control module's output driver.

Applies to these machines

  • 7J Series
  • 7210J
  • 6090MC
  • 6090RC
  • 6100MC
  • 6100RC
  • 6110MC
  • 6110RC
  • 8030
  • 8130
  • 8230
  • 8330
  • 8430
  • 8530
  • 9030
  • 9230
  • 9330
  • 9430
  • 9530
  • 9630
  • 7020 Series
  • 7220
  • 7320
  • 7420
  • 7520

Check the cause

  1. Restart the tractor and cycle the left turn signal to see if the code is intermittent and clears on its own

  2. Inspect all left turn signal bulbs (front, rear, and implements) for shorted filaments, internal damage, or incorrect wattage

  3. Inspect the wiring harness and connectors (especially the 7-pin implement connector) for chafed, pinched, or melted insulation causing a short to ground

  4. Check for incorrect controller configuration settings in the CLC

  5. Inspect the flasher control switch or relay for signs of overheating or internal failure

Repair steps

  1. Inspect and replace bulbs

    Access and remove all bulbs associated with the left turn signal circuit. Inspect for signs of a shorted filament or internal damage. Replace any incorrect or damaged bulbs with a new 12-volt, 21-watt bulb (e.g., part 57M7014).

  2. Test wiring and implement connector

    Disconnect the 7-pin implement connector to see if the fault code clears, which isolates the fault to the implement. If the fault persists, visually inspect the tractor's wiring harness and use a multimeter to check for continuity to ground on the power wire of the turn signal circuit.

  3. Verify controller configuration

    If the circuit and bulbs are in good condition, use a John Deere service tool to access CLC addresses 053 (Lighting Configuration 1) and 054 (Lighting Configuration 2). Ensure they match the tractor's actual lighting hardware. Check with a dealer for any available CLC software updates.

  4. Test flasher control switch

    If a separate flasher control switch is used, inspect it for signs of overheating or damage. Test the component by swapping it with an identical one from a different circuit to see if the fault follows the switch.

Parts you might need

(4)
  • Common bulb for turn signal and brake light applications; 21 watts, 1.75 amps rating.

  • Left Side Turn Signal Lamp

    TA14476

    Complete lamp assembly for various compact utility tractors.

  • Left Side Turn Signal Lamp

    RE215149

    Complete lamp assembly for many 5-series tractors.

  • Rotary-style switch used on a wide variety of older tractors, combines, and sprayers.

Get help to fix this fault by requesting a quote

Browse other John Deere codes