John Deere 000237.02 – CCU / ICC: Central Control Module Has Noted An Issue With The Stored Tractor Configuration Data

The Central Control Module has detected a mismatch or conflict in the stored tractor configuration data. Specifically, there is a discrepancy in the Vehicle Identification Number (VIN) reported between the machine's various control modules on the CAN bus. This typically occurs if a module is replaced with a new or used part from another machine, or if the data becomes corrupted. The system logs this as a security issue to prevent the use of incorrect or mismatched controllers, which could lead to unpredictable tractor operation or disabled functions.

• 5045E
• 5050E
• 5055E
• 5060E
• 5065E
• 5075E
• 5082E
• 5083E
• 5085E
• 5090E
• 5093E
• 5100E
• 5101E
• 5065M
• 5075M
• 5085M
• 5095M
• 5105M
• 5115M
• 5120M
• 5130M
• 7610
• 7710
• 7810
• 7720
• 7820
• 7920
• 8130
• 8230
• 8330
• 8430
• 8530
• 8230T
• 8330T
• 8430T
• 328D
• 5076E
• 7200
• 7410
• 7510
• 5E-5310
• 5095MH
• 5105ML
• 6110M
• 6120M
• 6130M

1. 1

   Restart the tractor by shutting it down, waiting a few moments, and restarting to see if a temporary CAN bus communication glitch clears the code

2. 2

   Check for other diagnostic trouble codes (DTCs), especially those indicating missing CAN messages, and resolve them first as communication failures can falsely trigger a VIN mismatch

3. 3

   Verify battery voltage and charging system function, as low system voltage during startup can cause controllers to malfunction and generate spurious codes

1. 1

   Access Diagnostic Mode

   Access the control unit addresses through the instrument cluster display. This may involve moving a fuse to a 'DIAG' position and using the turn signal and other switches to navigate menus.

2. 2

   Identify Mismatched Controller

   Access the information for each controller (CCU, ICC, ECU, etc.) and compare the stored VINs to identify which module contains the incorrect data.

3. 3

   Perform VIN Relearn/Programming

   Navigate to specific addresses within the mismatched controller's menu and input the correct 17-digit VIN. For a new controller, it may be possible to write the tractor's VIN into the module's memory (on some models, this can only be done once, within the first key cycle after installation). For used controllers, they must be reprogrammed with the correct VIN for the current tractor.

4. 4

   Seek Dealer Assistance

   If onboard controls do not allow for VIN programming or specific addresses are unknown, contact a John Deere dealer to reprogram the controller using the Service ADVISOR™ tool.