000237.14

John Deere 000237.14 – SFA: SFA Serial Number Mismatch

Issue description

A mismatch has been detected between the tractor's serial number (VIN) and the serial number stored in the Rear Chassis Module (SFA). This typically occurs when a new or different controller is installed but not electronically programmed with the correct vehicle serial number, causing the network to identify it as a foreign part. It acts as a security and safety measure to ensure compatible hardware and software are operating on the machine.

Applies to these machines

  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R

Check the cause

  1. Verify the fault code using the tractor's built-in diagnostic display or John Deere Service ADVISOR, noting any other active communication faults.

  2. Check service history or question the owner to determine if any electronic control units (ECUs/controllers) have been recently replaced (most common cause).

  3. Inspect battery terminals and alternator connections for low voltage issues, which can occasionally corrupt controller memory during startup.

  4. Connect Service ADVISOR to manually verify the serial number (VIN) stored in each individual controller to identify the mismatched module.

Repair steps

  1. Connect Service ADVISOR

    Connect the diagnostic laptop with John Deere Service ADVISOR to the tractor's diagnostic port.

  2. Identify mismatched controller

    Navigate through the Service ADVISOR menus to view the list of installed controllers and their stored VINs. Identify the controller that does not match the tractor's actual serial number plate.

  3. Initiate reprogramming

    Select the controller with the incorrect serial number and choose the reprogramming or 'payload file' installation function within Service ADVISOR.

  4. Load correct software/VIN

    Follow the on-screen prompts to load the correct software and/or directly input the tractor's serial number into the module. Ensure the tractor is in a safe, stationary location as this flashing process can take up to 40 minutes and disable some functions.

  5. Cycle power

    Once the reprogramming is complete, shut down the tractor, cycle the key switch, and restart the engine.

  6. Verify repair

    Reconnect with Service ADVISOR, clear all Diagnostic Trouble Codes (DTCs), and check for any returning active codes to ensure 000237.14 does not reappear.

Parts you might need

(4)
  • Potential OEM part number; verify by tractor serial number

  • Central Control Unit SFA

    AL113367

    Potential OEM part number; verify by tractor serial number

  • Central Control Unit SFA

    AL118389

    Potential OEM part number; verify by tractor serial number

  • Potential OEM part number for 6R tractors; verify by tractor serial number

Get help to fix this fault by requesting a quote

Browse other John Deere codes