002382.06

John Deere 002382.06 – RLC: Front Clearance Signal High Amps

Issue description

The electrical system has detected an abnormally high current draw in the front clearance light circuit. This condition typically indicates a short circuit to ground (or earth), where the electrical current bypasses its intended path and flows directly to the chassis. The Roof Lighting Control Unit (RLC) flags this fault to prevent damage to the wiring harness and the control module itself.

Applies to these machines

  • 6110M
  • 6120M
  • 6130M
  • 6145M
  • 6155M
  • 6175M
  • 6195M
  • 6110R
  • 6120R
  • 6130R
  • 6145R
  • 6155R
  • 6175R
  • 6195R
  • 6215R

Check the cause

  1. Perform a visual inspection of the front clearance lights, wiring, and connectors for physical damage, chafed or melted insulation, and corrosion, particularly where the wiring loom passes near metal edges.

  2. Isolate the circuit by disconnecting the front clearance lights from the harness, clearing the fault code, and turning the lights on. If the code does not return, the fault is in the fixture or bulb.

  3. Inspect the clearance light bulb for any signs of a broken or internally shorted filament.

  4. Test for a short circuit to ground using a multimeter set to continuity or a test light between the power wire and chassis ground (with battery and RLC disconnected).

  5. Perform a wiggle test on the wiring harness from the RLC to the lights while monitoring the multimeter to pinpoint intermittent shorts.

Repair steps

  1. Disconnect power

    Always disconnect the battery before beginning any electrical repairs for safety.

  2. Replace faulty bulb or socket

    If the issue is isolated to the bulb, replace it with a new one of the correct specification. If the bulb socket is corroded or damaged, replace the socket.

  3. Repair short circuit in wiring

    If a short to ground is detected, trace the affected wire, cut out the damaged portion, splice in a new piece of wire of the same gauge, and seal the repair with heat shrink tubing to protect from moisture and vibration.

  4. Replace RLC module

    If the fault persists after confirming the integrity of the wiring and components, replace the Roof Lighting Control Unit (RLC) as a last resort.

  5. Clear codes and test

    Reconnect the battery, clear the fault codes from the RLC, activate the front clearance lights, and ensure the fault code does not return.

Parts you might need

(5)
  • Verify match to the bulb being replaced

  • Bulb Holder / Socket

    R272960-JD

    Listed for end outline marker light

  • Common headlight bulb socket applicable to clearance lights

  • OEM reference, aftermarket LED options available

  • Roof Lighting Control (RLC) Module

    RE573556

    Multi-functional control module, highly specific to tractor configuration. Verify with dealer.

Get help to fix this fault by requesting a quote

Browse other John Deere codes