John Deere 002872.02 – CAB: Issue With The Signals From The Light Switch, Dash Module (FCC)
Issue description
The system has detected an issue with the signals coming from the main light switch or turn signal switch, specifically involving the dash module or Cab Control Unit (CAB). This indicates a potential problem with the communication or electrical circuit functionality of the light switch, which can manifest as a logic error, a short circuit, or both turn signals being activated simultaneously.
Applies to these machines
21 machines- 7210J
- 7715
- 7815
- 8130
- 8230
- 8330
- 8430
- 8530
- 9360R
- 9460R
- 4000 Series
- 7000 Series
- 8000 Series
- 9R Series
- S-Series Combines
- T-Series Combines
- W-Series Combines
- 8000 Series Harvesters
- 9000 Series Harvesters
- 3020
- 7410
Check the cause
Cycle the light or turn signal switch on and off to see if the intermittent fault clears.
Restart the tractor engine, particularly if the fault indicates both signals are activated.
Inspect the fuse box for any blown fuses related to the lighting or cab control circuits.
Visually inspect the wiring harness and connectors at the switch, control module, and cab mounts for chafing, pinching, corrosion, or loose connections.
Using a multimeter, check for battery voltage at the switch and test continuity in different switch positions.
Observe for related severe symptoms (e.g., hazard lights activating independently, corner post display shutting off, or machine shifting into park), which indicate a failing Cab Switch Module.
Repair steps
Disconnect power
Disconnect the battery before starting any electrical repairs for safety.
Access the switch or module
Locate the light switch or turn signal module on the steering column or in the dash console. Remove any necessary dash panels or shrouds to gain access.
Remove the faulty component
Carefully disconnect the electrical connector from the back of the switch or module (proceed with caution as older plastic connectors can be brittle). Remove retaining nuts or screws and extract the component.
Install the new component
Position the new switch or module, secure it with the previously removed hardware, and firmly reconnect the electrical connector.
Reassemble and test
Reinstall all panels and shrouds, reconnect the battery, turn the ignition on, and test all light and turn signal functions. Verify on the tractor's display that the fault code has cleared.
Parts you might need
(6)- Cab Switch ModuleRE333136
Substitutes to AXE46837. For S-series, T-series, and W-series combines.
- Cab Switch ModuleRE296764
For 8000 & 9000 Series Harvesters.
Cab Switch Module
RE272865Verify compatibility by serial number.
Cab Switch Module
RE296760For S-series, T-series, and W-series combines.
- Light SwitchAR28402
For older 24V diesel tractors like the 3020.
Turn Signal Control Module / Main Light Switch / Cab Switch Module
Generic part name. Verify exact part number using machine serial number.
Get help to fix this fault by requesting a quote