John Deere CAB002876.02 – CAB: Signal Switch Malfunction
Issue description
The Cab Control Unit (CAB) has detected a conflict or malfunction with the turn signal switch, such as both signals being activated simultaneously. This indicates the switch is not functioning properly, which directly affects the operation of the tractor's signaling system.
Applies to these machines
7 machines- 9230
- 9330
- 9430
- 9530
- 9630
- 4000 Series
- 4230
Check the cause
Cycle the ignition key switch to see if the diagnostic trouble code clears
Inspect for blown fuses and test the turn signal relay
Inspect the wiring harness around the steering column for loose connections, corrosion, or damage. Specifically check for wiring shorts in the red wire to the light switch
Verify switch operation, ensuring the turn signal switch is not stuck in the 'on' position and only operates when the ignition key is in the ON position
Repair steps
Access the switch
Remove the dash panels and the steering wheel column covers to gain access to the turn signal switch assembly.
Disconnect the switch
Gently disconnect the electrical connector from the back of the switch. Exercise caution as the plastic on older connectors can be brittle.
Remove the switch
Unscrew the retaining nut that holds the switch to the dash and remove the old assembly.
Install the new switch
Install the replacement switch, reconnect the electrical connector, and reassemble the dash and steering column components.
Parts you might need
(1)Example part number for 4230 tractor. Consult a John Deere dealer for the specific part number for your machine's serial number.
Get help to fix this fault by requesting a quote