John Deere 003509.03: Issue With 5v Supply Over 5v Detected in PTD Range Control Module Direct Drive

The system has detected an overvoltage condition in the 5v supply for the PTD Range Control Module Direct Drive. This may indicate a fault in the power regulation or a malfunction in the component identified by this code.

1. 1

   The 5v supply voltage

2. 2

   The PTD Range Control Module Direct Drive

3. 3

   The Range Module Direct Drive

1. 1

   Verify the 5v supply voltage

   Use a multimeter to measure the voltage at the 5v supply point. Ensure it is within the specified range.

2. 2

   Inspect the PTD Range Control Module Direct Drive

   Check for visible damage, loose connections, or signs of overheating on the PTD Range Control Module Direct Drive.

3. 3

   Inspect the Range Module Direct Drive

   Check for visible damage, loose connections, or signs of overheating on the Range Module Direct Drive.