John Deere 003509.06 – SFA: Front Chassis 5 Volt Supply High Amp Draw
Issue description
The Suspended Front Axle (SFA) control module is detecting a current draw on its 5-volt sensor supply circuit that is above the normal operating range. This high amperage condition points to an electrical overload, which could be caused by a short circuit in a sensor, the wiring harness, or an internal fault within a connected component.
Applies to these machines
6 machines- 6090MC
- 6090RC
- 6100MC
- 6100RC
- 6110MC
- 6110RC
Check the cause
Check for any other active diagnostic trouble codes that may provide context to the failure
Inspect fuses related to the SFA system (such as fuse F30) to see if they are blown, indicating an overcurrent situation
Visually inspect the front axle position sensors and any other sensors tied to the SFA module for physical damage
Thoroughly inspect the wiring harnesses connected to the SFA control module and its associated sensors for chafed or pinched wires, heat damage, or corrosion on connectors
Repair steps
Isolate the Faulty Component
The primary objective is to identify the source of the high current draw. This is often achieved by systematically disconnecting components from the affected 5-volt circuit.
Disconnect Sensors
Begin by disconnecting one sensor at a time from the SFA's 5-volt supply circuit. After each sensor is disconnected, clear the fault codes and operate the system to see if the 003509.06 code returns. If the code does not reappear with a particular sensor unplugged, that sensor or its immediate wiring is the likely culprit.
Inspect Wiring Harness
If disconnecting all sensors does not resolve the issue, the problem is likely within the wiring harness itself. Use a multimeter to test for a short to ground or continuity between the 5-volt supply wire and other wires in the harness.
Evaluate Control Module
If all external sensors and wiring have been verified as good, the SFA control unit itself could be faulty. However, control module failure is less common than wiring or sensor issues. It is advisable to have a John Deere dealership confirm this diagnosis before ordering a replacement.
Perform Calibration
If a position sensor or the SFA control unit is replaced, a system calibration will likely be necessary for the suspension to function correctly.
Parts you might need
(4)Suspended Front Axle Position Sensor
Part number differs based on tractor model and whether it is for the left or right side.
SFA Wiring Harness
Specific to the tractor model.
Suspended Front Axle (SFA) Control Unit
Must be the correct part for the specific tractor model.
- Relay Module57M8056
OEM John Deere part. Relays can cause various voltage and current-related issues; verify fitment for your specific model.
Get help to fix this fault by requesting a quote