3587

John Deere 3587 – ECU: Auto Ether Control Circuit Fault

Issue description

The fault code indicates an electrical malfunction in the Auto Ether Control Circuit, which manages the automatic injection of ether into the air intake manifold to aid cold weather starting. The Engine Control Unit (ECU) monitors this circuit and logs the fault when it detects an anomaly in the wiring, the ether injection solenoid, or the control module itself.

Applies to these machines

  • 310K
  • K-Series
  • L-II Series
  • 8R
  • 8RT
  • 8RX
  • 9400
  • 9500
  • 9600
  • 6.8L

Check the cause

  1. Visually inspect the wiring harness and connectors for the ether injection solenoid for signs of damage, chafing, corrosion, or loose connections

  2. Check the ether injection nozzle at the engine's intake for clogs that could prevent ether from being sprayed

  3. Listen for solenoid operation (a clicking sound) when the ignition is turned on in cold conditions

Repair steps

  1. Test the solenoid

    Disconnect the electrical connector from the ether injection solenoid. Using a multimeter, check for voltage (typically 12V or 24V) at the connector when the key is in the 'start' or 'on' position. Test the solenoid's continuity; there should be no continuity when de-energized, and continuity when voltage is applied. Replace if it receives power but does not activate.

  2. Inspect and test wiring

    If there is no voltage at the solenoid connector, trace the wiring back to the ECU. Check for continuity in the power and ground wires of the circuit. Inspect for any breaks, shorts, or high resistance in the wiring.

  3. Check fuses and relays

    Inspect the fuses and relays related to the engine control and starting systems. Replace any blown fuses or faulty relays that may be interrupting power to the ether control circuit.

  4. Inspect the ECU

    If the solenoid, wiring, fuses, and relays are found to be in good condition, the issue may lie with the ECU. Use a diagnostic scan tool to further test the ECU's functionality.

Parts you might need

(5)
  • Ether Start Aid Solenoid Valve

    AT183422

    Verify correct part number for your specific machine model and serial number

  • Ether Injection Solenoid

    AT39623

    Substitute part: RE48310

  • Cold Weather Starting Solenoid Kit

    BRE10551

    Substitute part: BXX10955

  • Verify fitment with dealer

  • 24 Volt Ether Starting Aid Solenoid

    AT345746

    For 24V systems

Get help to fix this fault by requesting a quote

Browse other John Deere codes