520255.09

John Deere 520255.09 – HV1 / HCC: Internal CAN BUS Message Missing From The HCC Software. (HV1)

Issue description

Communication failure on the tractor's Controller Area Network (CAN) bus. Specifically, the expected data messages from the HCC (Hitch Control Center) software are missing, interrupted, or not being received by the HV1 module.

Applies to these machines

  • 5090M
  • 5100M
  • 5100MH
  • 5100ML
  • 5115M
  • 5115ML

Check the cause

  1. Cycle tractor power by turning off the key switch to attempt a vehicle recovery

  2. Verify system voltage by inspecting batteries, alternator, and system fuses (such as F30)

  3. Inspect the rear hitch control lever and external switches for damage, wear, or simultaneous activation

  4. Examine CAN bus wiring and connections between the HCC and HV1 modules for looseness, corrosion, or physical damage

Repair steps

  1. Power Down

    Turn off the engine, remove the key, and disconnect the battery to ensure safety while working on the electrical system.

  2. Locate the Modules

    Locate the Hitch Control Center (HCC) module and the Hitch Valve 1 (HV1) control unit on the rear chassis/hitch assembly.

  3. Disconnect and Inspect Harnesses

    Disconnect the wiring harness connectors at both the HCC and HV1 modules. Inspect the pins for corrosion, moisture, or pushed-out pins.

  4. Test CAN Bus Continuity

    Using a multimeter, verify data transmission lines by testing the CAN bus wiring between the control lever, HCC, and HV1 for continuity and short circuits.

  5. Repair Wiring

    Replace or repair any faulty wiring, damaged pins, or corroded connectors found during the inspection.

  6. Reconnect and Test

    Reconnect all modules securely, reconnect the battery, and start the tractor. Cycle the hitch to see if the system recovers.

  7. Software/Module Replacement

    If the wiring is intact and the code persists, the fault lies within the module hardware or software. The HCC software may require a reflash, or the HV1/HCC control unit may need to be replaced and recalibrated by a John Deere dealer.

Parts you might need

(3)
  • Hitch Control Unit (HCC) / BCU

    AL204145

    Exact fitment must be verified against the specific tractor's serial number

  • Hitch Valve 1 Control Unit (HV1)

    OEM part number requires dealer lookup based on exact tractor configuration

  • Rear Hitch Control Lever / Switch

    AL172871

    External remote lift control switch for 5M series

Get help to fix this fault by requesting a quote

Browse other John Deere codes