John Deere 520958.14 – TID (Tractor Information Display) or TIP (Tractor Information Processor): INFORMATION FOR OPERATOR: Shifting Transmission Not Permitted / Wheel Speed Limited

Triggered when the transmission is not allowed to shift into the requested gear or range because another control software module is actively requesting a travel speed limit. It is primarily an informational code alerting the operator that a system limitation is preventing the shift.

• 6110R
• 6120R
• 6130R
• 6145R
• 6155R
• 6175R
• 6195R
• 6215R
• 8R Series
• 8RW Series
• 8245R
• 8400R
• 7R Series

1. 1

   Verify the CommandCenter™ display settings to see if a maximum travel speed limit has been manually set by the operator

2. 2

   Look for other active diagnostic trouble codes (DTCs) from other control modules (such as the Engine ECU or Transmission TCU) that may be forcing a 'come home' mode

3. 3

   Verify if an attached implement is sending a message requesting a speed limit over the CAN bus

1. 1

   Adjust Speed Settings

   Access the CommandCenter™ display and review the maximum travel speed settings. Adjust or remove the speed limit setting if it was set unintentionally.

2. 2

   Perform a System Reset

   Perform a system reset (key cycle) to attempt clearing the error, as this can sometimes resolve temporary software communication glitches.

3. 3

   Diagnose Root Cause Codes

   If the code persists, diagnose and repair the root cause associated with any other active fault codes that are forcing the tractor into a speed-limited state.

4. 4

   Update Control Software

   Ensure that the TID control software is updated to the latest version to fix known bugs and improve system stability. This typically requires a John Deere dealer using Service Advisor and a USB drive to flash the CommandCenter display.