522279.05

John Deere 522279.05 – BRC: Secondary Brake Control Valve Current Low

Issue description

The electrical current in the circuit for the secondary brake control valve is below the manufacturer's specified range. The fault is logged when the system detects a problem with the current in the secondary brake control valve, suggesting a potential electrical failure.

Applies to these machines

  • 9230
  • 9330
  • 9430
  • 9530
  • 9630
  • 8130
  • 8230
  • 8330
  • 8430
  • 8530

Check the cause

  1. Visually inspect the wiring harness and connectors associated with the secondary brake control valve for damage, corrosion, or loose connections.

  2. Check for other related fault codes, particularly those indicating BRC supply voltage issues or communication errors.

  3. Perform a power cycle by turning the tractor off and restarting it to see if the fault clears.

  4. Inspect fuses related to the brake control circuit, specifically checking fuse F30.

  5. Perform a basic system function check: with the vehicle in park and the engine running, cycle the secondary brake lever to observe any changes in the fault status.

Repair steps

  1. Isolate the fault

    Use diagnostic tools to test the continuity and resistance of the wiring harness leading to the secondary brake control valve.

  2. Test the valve solenoid

    Test the solenoid on the secondary brake control valve to determine if it is functioning correctly or if it has an internal short or open circuit.

  3. Repair or replace components

    If the wiring is damaged, repair or replace the affected section of the harness. If the valve solenoid is faulty, replace the secondary brake control valve.

  4. Calibrate the system

    If the valve was replaced, perform a system calibration procedure to prevent related fault code BRC 522279.13 (Secondary Brake Control Valve Not Calibrated).

Parts you might need

(7)
  • Brake Valve

    RE159296

    Compatible with 9030 series tractors. Verify fitment by serial number.

  • Brake Valve

    RE175393

    Compatible with 9030 series tractors. Verify fitment by serial number.

  • Brake Valve

    RE262395

    Compatible with 9030 series tractors. Verify fitment by serial number.

  • Brake Control Valve

    RE263240

    Manages hydraulic pressure in the braking system.

  • Brake Control Valve

    AT437075

    Verify fitment by serial number.

  • Compatible with 9030 series tractors. A faulty switch could potentially trigger related faults.

  • Component within the brake control valve assembly.

Get help to fix this fault by requesting a quote

Browse other John Deere codes