522280.00

John Deere 522280.00 – BRC, XMC, XMB: Secondary Brake Pressure Sensor Fault

Issue description

This fault code indicates a problem with the secondary brake pressure sensor. The system has detected that the sensor reading is higher than expected when the brake is not engaged, or there is a voltage/circuit problem (such as voltage being too high, too low, or a general circuit fault). When this fault is active, the secondary brake system is typically disabled as a safety precaution.

Applies to these machines

  • 8130
  • 8230
  • 8330
  • 8430
  • 8530
  • 8225R
  • 8245R
  • 8270R
  • 8295R
  • 8320R
  • 8345R
  • 9230
  • 9330
  • 9430
  • 9530
  • 9630
  • 7R Series
  • 5M Series
  • Combines
  • Sprayers

Check the cause

  1. Perform an initial system reset: Place the tractor in Park with the engine running, cycle the secondary brake lever, restart the engine to attempt vehicle recovery, and if the code persists, cycle the key switch (tractor power) off and on again

  2. Inspect the area around the batteries and alternator for any signs of damage or accumulated debris that could affect the electrical system

  3. Check the wiring harness and connectors leading to the secondary brake pressure sensor for any visible damage, corrosion, or loose connections

  4. Check fuse F30, which is associated with the BRC supply voltage. A blown fuse can indicate an underlying electrical issue

  5. Check for other active codes. The presence of other Brake Control Unit (BRC) codes can help pinpoint the issue. For example, codes related to BRC supply voltage (BRC 000168.04) or calibration (BRC 522280.13) can provide additional context

Repair steps

  1. Locate the sensor

    Consult the specific technical manual for the machine being serviced to find the exact position of the secondary brake pressure sensor within the hydraulic brake system.

  2. Test sensor circuit voltage and ground

    With the ignition off, disconnect the electrical connector from the secondary brake pressure sensor. Turn the ignition on (without starting the engine) and use a multimeter to check for a reference voltage (typically 5V or 12V, depending on the system) at the appropriate pin on the harness connector. Check for continuity to a known good ground from the ground pin on the harness connector.

  3. Inspect signal wire and test resistance

    Inspect the signal wire for any shorts to power or ground. With the sensor disconnected, measure the resistance across the sensor's terminals and compare this reading to the specifications in the service manual. An out-of-spec reading indicates a faulty sensor.

  4. Replace the sensor

    If the sensor is determined to be faulty, it must be replaced. Ensure the hydraulic system is depressurized before removing the old sensor to prevent fluid loss and injury. Install the new sensor, torque it to the manufacturer's specification, and reconnect the electrical connector.

  5. Calibrate the new sensor

    After replacing the sensor, a calibration may be necessary. Perform a calibration procedure using a John Deere service tool or through the machine's diagnostic display to clear any 'Secondary Brake Pressure Not Calibrated' codes (e.g., BRC 522280.13).

Parts you might need

(3)
  • Listed for a wide range of 7R, 8R, and 9R series tractors.

  • Brake Pressure Sensor

    AT435543

    Applicable to some agricultural models, as well as construction and forestry equipment.

  • Used in fluid or air brake applications.

Get help to fix this fault by requesting a quote

Browse other John Deere codes